Cub Cadet 221 LHP Single-Stage Snow Thrower 221 LHP Operator's Manual - Page 10

Installing the Recoil Starter Handle - snow thrower

Get Cub Cadet 221 LHP Single-Stage Snow Thrower PDF manuals and user guides View all Cub Cadet 221 LHP Single-Stage Snow Thrower manuals
Add to My Manuals
Save this manual to your list of manuals

Page 10 highlights

6. Slide the rubber bellow over the universal joint. See Figure 3-10. Rubber Bellow Figure 3-10 Installing the Recoil Starter Handle 1. Remove the eye bolt and handle knob from the manual bag. 2. Place the eye bolt and handle knob on the upper handle as shown in Figure 3-11. Do not fully tighten the hardware until instructed to do so. Recoil Starter Handle Eye Bolt Handle Knob Figure 3-11 NOTE: The opening of the eye bolt should face toward the back of the snow thrower. 3. Slowly pull the recoil starter handle up towards the eye bolt. 4. Slip the recoil starter rope into the eye bolt from the back of the snow thrower. See Figure 3-11. 5. Securely tighten the eye bolt and handle knob. 10 Section 3- Assembly & Set-Up

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
10
S
ECTION
3— A
SSEMBLY
& S
ET
-U
P
6.
Slide the rubber bellow over the universal joint. See Figure
3-10.
Rubber Bellow
Figure 3-10
Installing the Recoil Starter Handle
1.
Remove the eye bolt and handle knob from the manual bag.
2.
Place the eye bolt and handle knob on the upper handle
as shown in Figure 3-11. Do not fully tighten the hardware
until instructed to do so.
Eye Bolt
Handle
Knob
Recoil Starter Handle
Figure 3-11
NOTE:
The opening of the eye bolt should face toward the
back of the snow thrower.
3.
Slowly pull the recoil starter handle up towards the eye
bolt.
4.
Slip the recoil starter rope into the eye bolt from the back
of the snow thrower. See Figure 3-11.
5.
Securely tighten the eye bolt and handle knob.