Cub Cadet 945 SWE Two-Stage Snow Thrower 945 SWE Operator's Manual - Page 18
Service
View all Cub Cadet 945 SWE Two-Stage Snow Thrower manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Service 7 Belt Replacement Belt Removal Preparation 4. Loosen the bolt shown in Figure 7-3 securing the belt keeper bracket and remove the other bolt. Push the belt keeper bracket up off the engine pulley. Refer to Figure 7-3. 1. Disconnect the chute crank assembly at the discharge chute end by removing the hairpin clip and the flat washer. Refer to Figure 7-1. Remove Loosen Figure 7-3 Auger Belt Replacement Figure 7-1 To remove and replace your snow thrower's auger belt, proceed 2. Remove the hex screws and lock nuts securing the forward as follows: end of the support tubes to the back of the auger housing, 1. Remove the hairpin clip and flat washer from the ferrule and pivot the tubes upward. in order to disconnect the auger idler rod from the brake 3. Remove the plastic belt cover on the front of the engine by bracket assembly. See Figure 7-4. removing the three self-tapping screws. See Figure 7-2. Figure 7-2 18 Figure 7-4 NOTE: Make sure to maintain the location of the ferrule on the idler rod.