Cub Cadet CC 46ES CC 46ES Operator's Manual - Page 17
Replacing Battery
View all Cub Cadet CC 46ES manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
4. Press inward on tab on the engine baffle to release it from the baffle bracket. See Fig. 7-3. 6. Replace with new belt, making sure belt is firmly seated on engine pulley while pulling from the other side and sliding it around the transmission pulley. 7. Reattach engine baffle and reassemble blade as described in the previous section. 8. Turn mower back over and make sure belt is seated on the transmission pulley. Tighten screw loosened earlier to secure belt tension spring to the transmission. 9. Reassemble front drive cover. Replacing Battery WARNING: Batteries contain sulfuric acid which may cause burns. Do not short circuit or mutilate batteries in any way. Do not put batteries in fire as these may burst or release toxic materials. 1. Loosen star knobs securing upper and lower handles and carefully fold the upper handle down toward the lower handle as shown in Fig. 7-5. Figure 7-3 5. Slide belt off of engine pulley and thread through the opening in the deck. See Figure 7-4. Figure 7-4 Figure 7-5 2. Remove the two screws securing battery cover to battery housing and place them to the side. See Fig. 7-5. 3. Open battery cover, remove positive and negative leads from battery, remove and replace with new battery. Connect the positive lead to the positive side of the battery pack, then connect the negative side. Section 7 - Service 17