Cub Cadet CC 800 Operation Manual - Page 22
Cutting Deck Removal
View all Cub Cadet CC 800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Service Cutting Deck Removal WARNING! Before performing any maintenance or repairs, disengage blades, stop engine and remove key (if equipped) to prevent unintended starting. To remove the cutting deck, proceed as follows: 1. Remove the belt cover by removing the three screws (a) and washers (b) which secure it to the frame. See Figure 7-1. WARNING: Do not operate mower without the belt cover installed. Failure to follow this instruction could result in personal injury or property damage. 7 (a) (b) (a) (b) Figure 7-2 (a) 6. Remove the belt keeper rod and remove the deck belt from (b) around the mower's engine pulley. 7. Looking at the cutting deck from the left side, locate and carefully remove the hairpin clips (a) that secure the deck supports on the rear left side and front left side of the deck. See Figure 7-3. (b) (a) (a) Lift Arm (a) Figure 7-1 2. Place the deck height lever in its highest position. 3. Position wood blocks at various places under the deck's edge. These will temporarily support the deck as you unmount it. 4. Use the deck height lever to lower the deck, so that it rests on the wood blocks. 5. Remove the screw (a) and flange nut (b) which secures the belt keeper rod to the left side of the mower's frame. See Figure 7-2. Figure 7-3 8. Repeat Step 7 on the mower's right side. 9. Carefully remove the front deck supports from the deck lift arms. See Figure 7-3. 22