Cub Cadet CC3600 Operation Manual - Page 18
Service
View all Cub Cadet CC3600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Service 7 DO NOT RETURN THIS PRODUCT TO YOUR RETAILER. If you have difficulty assembling this product or have any questions regarding the controls, operation, or maintenance of this machine, you can seek help from the experts. ◊ Call a Customer Support Representative at 1-877-282-8684 Off-Season Storage The following steps should be taken to prepare your pressure washer for storage. • Drain all water from high pressure hose and wrap it onto hose wrap. • Drain all water from the spray gun and wand by holding spray gun in a vertical position with nozzle end pointing down and squeezing trigger. Store in gun holder. • Wrap up and secure detergent siphon hose so it is protected from damage. • Refer to engine manual for correct engine storage instructions. • Store pressure washer in a dry, clean area. Do not store next to corrosive materials, such as fertilizer. When storing any type of power equipment in a poorly ventilated or metal storage shed, care should be taken to rust-proof the equipment. Using a light oil or silicone, coat the equipment, especially cables and all moving parts of your pressure washer before storage. Pump The manufacturer recommends using MTD Genuine Parts Pump Guard (490-245-V011) or equivalent when storing the unit for more than 30 days and/or when freezing temperatures are expected. MTD Genuine Parts Pump Guard (490-245-V011) is environmentally friendly. NOTE: Using pump guard helps provide proper lubrication to the internal seals of the pump regardless of temperature or environment. NOTICE: Risk of property damage. Use only MTD Genuine Parts Pump Guard (490-245-V011) or equivalent. Other products could be corrosive and/or contain alcohol which may cause pump damage. 1. Turn off pressure washer and disconnect hoses from pump. 2. Unscrew bottle valve from Pump Guard bottle and remove seal. 3. Screw bottle valve back onto bottle. 4. Attach bottle to water inlet of pump. 5. Squeeze bottle to inject contents into pump. 6. With ignition switch off, simultaneously pull starter rope and squeeze bottle. Repeat until protector fluid exits pump outlet. NOTE: This step may require two people. Specifications Model PSI Max* GPM Max* High Pressure Hose CC3400 3400 2.5 25 ft. (7.6 m) CC3600 3600 2.5 25 ft. (7.6 m) CC4033 4000 3.3 50 ft. (15.2 m) Presure of Inlet 20-100 PSI Water 20-100 PSI 20-100 PSI Inlet Water cold tap cold tap cold tap (100 °F max) (100 °F max) (100 °F max) Soap Consumption Rate 10% max 10% max 10% max * Rated Pressure and Rated Water Flow is within manufacturing tolerance of (+/- 10%). In a continued commitment to improve quality, the manufacturer reserves the right to make component changes, design changes, or specification changes when necessary and without notice. * Rated Pressure and Rated Water Flow is within manufacturing tolerance of (+/- 10%). In a continued commitment to improve quality, the manufacturer reserves the right to make component changes, design changes, or specification changes when necessary and without notice. 18