Cub Cadet PRO Z 760 L Operation Manual - Page 13
Operation
View all Cub Cadet PRO Z 760 L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
OPERATION A R W† Q F G† C H E D Y U W† W† I I X1 X1 V X2 † if equipped Figure 22 NOTE: This Operator's Manual covers several models. Mower features may vary by model. Not all features in this manual are applicable to all mower models and the mower depicted may differ from yours. NOTE: All references in this manual to the left or right side and front or back of the machine are from the operating position only. Exceptions, if any, will be specified. A. RH AND LH DRIVE CONTROL LEVERS The RH and LH control levers are located on each side of the operator's seat. These hinged levers pivot outward to open space to permit the operator to either sit in the mower seat, or to dismount the mower. The levers must be fully opened out and in the neutral position to start the mower engine. Each lever controls the respective RH or LH transmission. These levers control all of the movements of the mower. Driving and steering utilizing these control levers is quite different from conventional mowers, and will take some practice to master. Refer to Driving the Mower for instructions on using the control levers. B. TRANSMISSION BYPASS LEVER/RODS WARNING Do not tow the mower, even with the bypass valves engaged. Serious transmission damage will result from doing so. 1. Parker Transmission (if equipped) - The transmission bypass lever is located next to the LH console to the left of the operator's seat. When engaged the valves open a bypass within the hydrostatic transmissions. Refer to the Set-Up section for instructions on using the bypass feature. 2.Hydro-Gear Transmission (if equipped) The transmission bypass rods (one for each RH and LH transmission) are located on the rear of the mower, below the engine. When engaged, the two rods open a bypass within the hydrostatic transmissions, which allows the mower to be pushed short distances by hand. Refer to the Set-Up section for additional instructions. C. IGNITION SWITCH The ignition switch is located on the RH console to the right STOP of the throttle control. The ignition switch has three positions as follows: OFF - The engine and electrical system are turned off. ON - The mower electrical system is energized. START - The starter motor will turn over the engine. Release the key immediately when the engine starts. NOTE: To prevent accidental starting and/or battery discharge, remove the key from the ignition switch when the mower is not in use. D. POWER TAKE-OFF (PTO) KNOB The PTO knob is located on the RH console to the right of the operator's seat. The PTO knob operates the electric PTO clutch mounted on the bottom of the engine crankshaft. Pull the knob upward to engage the PTO clutch, or push the knob downward to disengage the clutch. The PTO knob must be in the OFF position when starting the engine. E. HOUR METER & SERVICE MINDER (IF EQUIPPED) The hour meter and service minder is located on the RH console to the right of the operator's seat. It records the hours that the mower has been operated and engine speed (RPM) in the digital display. Hour Meter (if equipped) The hour meter is activated whenever the ignition switch is turned to the ON position. Keep a record 0.0 of the actual hours of operation to assure all maintenance procedures are completed according to the instructions in this Operator's Manual and the Engine Operator's Manual. 13