Cub Cadet RZT 46 RZT 42 Operator's Manual - Page 32
& 54 Deck
View all Cub Cadet RZT 46 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
4. Remove the belt from the spindle pulleys. 5. Install the new belt around the spindle pulleys as shown and reinstall the belt covers. See Figure 7-9. 6. Place the belt around the idler pulleys removed in step 3 with the "V" side facing in. Once in place, reinstall all the hardware and tighten the flange lock nut to secure the assembly. See Figure 7-10. 7. Route the belt as shown in Figure 7-10 and then reinstall the deck (refer to Deck Installation on page 30). 50" & 54" Deck 1. Remove the deck from beneath the tractor, (refer to Deck Removal on page 28). 2. Remove the hex washer screws securing the belt covers to the deck. See Figure 7-11. Hex Washer Screws Spindle Pulley Belt Cover 3. Remove the two idler pulleys by removing the hex screws and flange lock nuts that secure them to the deck and the idler arm. See Figure 7-12. Do not lose any of the hardware when removing the hex screw and flange lock nut. Hex Screw Pulley Cap Hex Screw Idler Pulley Idler Pulley Spacer Belt Guard Belt Guard Flange Lock Nut Idler Arm Flange Lock Nut Belt Guards Idler Pulley Spindle Pulley Idler Arm Spindle Pulley Figure 7-12 Figure 7-13 NOTE: Take note of the position of the belt guards to ensure they are properly re-installed. 4. Remove the belt from the spindle pulleys. 5. Install the new belt around the spindle pulleys as shown and reinstall the belt covers. See Figure 7-11. 6. Place the belt around the idler pulleys removed in step 3 with the "V" side facing in. Once in place, reinstall all the hardware and tighten the flange lock nut to secure the assembly. See Figure 7-12. 7. Route the belt as shown in Figure 7-12 and then reinstall the deck (refer to Deck Installation on page 30). 32 Section 7- Service