Cub Cadet TANK L 60 KW TANK L 60 KW Operator's Manual - Page 19

4.25" 3.25" 2.25" 1.25" 4.50" 3.50" 2.50" 1.50" 4.75" 3.75" 2.75" 1.75" 5" 4" 3" 2" 1" Deck Height Index The deck height index consists of several holes located on the left of the foot platform. Each hole corresponds to a 1⁄4" change in the deck height position ranging from 1" at the lowest notch to 5" at the highest notch. Deck Lift Pedal The deck lift pedal is located on the left front corner of the foot platform, and is used to raise and lower the mower deck. To raise the mowing deck to the transport position, push the pedal all the way forward until the deck lock rod snaps into position. To remove the deck from the transport position push forward on the deck lift pedal and pull up on the deck lock rod. To position the deck push the pedal all the way forward, remove the clevis pin and reinsert it in the desired cutting height and slowly release pressure on the pedal until you reach the clevis pin. Deck Lift Release Lever The deck lift release lever is located on the left side of the operator's seat and is used to lock the deck in the transport position. Press down on the deck lift pedal and lift up on the deck lift release lever to release the deck. Transmission Oil Expansion Reservoir (Not Shown) The transmission oil expansion reservoir is connected by hoses to the RH and LH transmission assemblies, and is located under the seat. The function of the reservoir is to hold the natural expansion of transmission oil that occurs as the transmission warms up during operation. DO NOT FILL THE RESERVOIR. Under normal operating conditions, no oil should be added to the reservoir. The COLD oil level should be approximately 1⁄4" above the bottom of the reservoir. NOTE: Prior to the initial operation of the tractor, the oil level in the reservoir may be slightly higher than the maximum due to air in the oil lines. Operation of the tractor will eventually purge the air from the lines and the oil level will settle to the maximum. Fuel Gauge There is a fuel gauge on top of each of the two fuel tanks and measures the fuel level in each tank. Fuel Valve The fuel valve is located behind the seat on the right side of the frame. RIGHT FUEL TANK The valve switches the fuel flow from the right and left tank and also L R can shut of fuel flow to the engine. Rotate the valve to the right to open the flow from the right fuel tank. Rotate the valve to the left to open LEFT FUEL TANK OFF I23688 the flow from the left tank. To shut off fuel from both tanks rotate the valve 90° towards the front of the tractor. See the Operation section for more information on using the fuel valve. Accessory Switch Receptacles The three receptacles for AUX. optional accessories are on the RH console. See the Attachments & Accessories section for information. The receptacles are for switches for an optional electric deck lift, lights and/or an auxiliary switch. LIGHTS DECK LIFT Tool Box The tool box is located on the right side of the tractor between the seat and the console. Transmission Bypass Levers The transmission bypass levers (one for each the RH and LH transmission) are located under the tractor on the front of each transmission inside the rear wheels. The levers are connected to a valve bracket that allows the levers to be controlled from the parking brake. When engaged the two valves open a bypass within the hydrostatic transmissions. Refer to the Assembly & Set-Up section for instructions on using the bypass feature. Section 4 - Controls & Features 19