Cub Cadet XT1 LT50 FAB Operation Manual - Page 15
Operation
View all Cub Cadet XT1 LT50 FAB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
OPERATION D1 M D2 D C D3 P N O L G A E H K B I F Q J Figure 25 NOTE: This Operator's Manual covers several models. Tractor features may vary by model. Not all features in this manual are applicable to all tractor models and the tractor depicted may differ from yours. NOTE: All references in this manual to the left or right side and front or back of the tractor are from the operating position only. Exceptions, if any, will be specified. A. FORWARD DRIVE PEDAL Depress the forward drive pedal forward to allow the tractor to travel forward. The further forward the pedal is depressed, the faster the tractor will travel. The pedal will return to its original/ neutral position when it is not depressed. B. REVERSE DRIVE PEDAL Depress the reverse drive pedal downward to allow the tractor to travel backward. The further downward the pedal is depressed, the faster the tractor will travel. The pedal will return to its original/neutral position when it is not depressed. C. BRAKE PEDAL Depress the brake pedal while the tractor is in use to stop the tractor and for setting the parking brake. NOTE: The brake pedal must be fully depressed to start the tractor. Refer to Safety Interlock System for more information. D. THROTTLE/CHOKE CONTROL LEVER, THROTTLE CONTROL, OR ELECTRONIC GOVERNOR CONTROL 1. Throttle/Choke Control Lever (If equipped) - Push the throttle/choke control lever forward to increase the engine speed. The tractor is designed to operate with the throttle/choke control lever at full throttle (FAST) when the tractor is being driven and the mower deck is engaged. Pull the throttle/choke control lever rearward to decrease the engine speed. When starting the engine, push the control lever fully forward into the CHOKE position. After starting and warming the engine, move the control lever rearward until you feel it move past the choke detent. Throttle is not meant to control unit speed, throttle should remain in high speed while operating blades. 2. Throttle Control (If equipped) - Push the throttle control lever forward to increase the engine speed. The tractor is designed to operate with the throttle control lever at full throttle (FAST) when the tractor is being driven and the tractor deck is engaged. Pull the throttle control lever rearward to decrease the engine speed. 15