Cuisinart CHW-14 Instruction Manual - Page 9

CLEANING AND MAINTENANCE Always turn unit off and remove the plug from the electrical outlet before cleaning. Lift up the Coffeemaker reservoir cover. Remove and discard the paper filter and ground coffee. The filter basket can be washed in warm, soapy water and rinsed thoroughly, or cleaned in the upper rack of the dishwasher. Dry all parts after use. Do not put any water in the unit once the filter basket has been removed. Wipe the area under the filter basket with a damp cloth. Remove the lid of carafe and discard any remaining coffee. The carafe and lid can be washed in warm, soapy water and rinsed thoroughly, or placed in a dishwasher. The carafe and carafe lid should be placed on the upper rack only. Do not use any scouring agents or harsh cleansers on any part of the Coffeemaker. Never immerse base unit in water or other liquids. To clean base, simply wipe with a clean, damp cloth and dry before storing. Fingerprints and other blemishes on the housing can be washed off with soap and water or a nonabrasive cleaning solution. Wipe resting plate with a clean, damp cloth. Never use rough, abrasive materials or cleansers to clean the resting plate. Do not dry the inside of the water reservoir with a cloth, as lint may remain. Maintenance: Any other servicing should be performed by an authorized service representative. EMPTYING THE HOT WATER RESERVOIR If your Hot Water System has not been used for more than one week, or if you plan to store your Coffee PLUS® unit, we suggest emptying the reservoir completely. Place it over the sink, and pull the water release tab from the bottom of the unit to drain the Hot Water System reservoir. Once empty, replace the release tab. NOTE: Hot water reservoir should be emptied only when the unit is cool. To avoid injury, do not empty the reservoir when there is hot water in the unit. decalcification Decalcification refers to the removal of calcium deposits that form over time on the metal parts of the coffeemaker. To Decalcify Your Coffeemaker For best performance from your Coffeemaker, decalcify the unit from time to time. The frequency depends upon the hardness of your tap water and how often you use the Coffeemaker. The flashing Clean light will indicate when unit should be cleaned. If the Clean light begins to flash when the Coffeemaker is turned on, it is telling you that the calcium buildup is interfering with the functioning of your Coffeemaker and the flavor of your coffee. To clean, fill the water reservoir to capacity with a mixture of ¹⁄³ white vinegar and ²⁄³ water. Press the Clean button. When the Clean light glows, turn the Coffeemaker on by pressing the On/Off button. The Clean light will shine steadily. The Coffeemaker is now in clean mode. One cycle should be sufficient to adequately clean the Coffeemaker. When the cycle is completed and the five beeps sound, the Coffeemaker will shut off. Turn the Coffeemaker on to see if the Clean light continues to flash. If it does, turn it off and then repeat the cleaning procedure with a fresh solution of vinegar and water. If the Clean light no longer flashes, turn the Coffeemaker off and then run one cycle of fresh cold water through the unit before using the unit again to brew coffee. Notes on the Clean Function Pressing the Clean button cancels all other settings. If it is pressed accidentally, press it again to return the Coffeemaker to all its previous settings. Pressing On/Off will also exit the clean mode and turn the Coffeemaker off. To Decalcify Your Hot Water System We recommend you clean your Hot Water System twice a year to remove any calcium scale residue from the heating element. 1. D ispense and dispose of any water in the reservoir until the Add Water light flashes. 2. A dd 32 oz. of white vinegar to the Hot Water reservoir. Turn the unit on to heat the vinegar. 3. D ispense 16 oz. of vinegar and dispose. This will fill the inner tank. 4. L et the vinegar solution sit in the unit for 20 minutes. Do not dispense during this time. 5. A fter 20 minutes, turn the unit off and allow hot vinegar to cool. Then drain the internal reservoir over a sink by removing the water release tab from the bottom of unit. 6. W hen vinegar has completely drained, replace tab. 7. R efill reservoir with water and drain the internal reservoir again (by removing tab at the bottom of the unit) to flush thoroughly. Replace tab. NOTE: If water has a vinegar taste or smell, continue to dispense water until taste or smell is gone. 9