Cuisinart CSB-78 CSB-78 Manual - Page 6
Attach/Detach charger handle, to motor body., CHOPPER/GRINDER ATTACHMENT, REVERSIBLE BLADE - cordless hand blender
UPC - 086279023407
View all Cuisinart CSB-78 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
2. Attach/Detach charger handle 2a. to motor body. Thumb grip a. After batteries are fully charged, remove charger handle from wall socket. Push down on thumb grip and slide the plug to the retracted position inside the housing. Push thumb grip In b. Press the release button. Align two slots on bottom of charger with two tabs on 2b. top of motor body. Press together until you hear a click and the two sections fit together without gaps. c. To detach: Hold motor body firmly in one hand. Detach charger handle by pressing release button located at top of motor body, then pull charger handle away from motor body by lifting up with other hand. Press release button to separate or attach Note: Detach the changer handle from the motor body after each use. Chopper/Grinder Attachment E J G H B I F A C D A. Chopper/Grinder Prep Bowl B. Cover Slots (3) for Attaching Cover C. Metal Blade Assembly Shaft D. Rubber Feet E. Blade Assembly F. Blade Ring G. Plastic Blade Sheath H. Chopper/Grinder Cover I. Lift Tabs J. Chopper/Grinder Spline Reversible Blade The Cuisinart® Cordless Rechargeable Hand Blender chopper/ grinder attachment is equipped with a reversible blade. This blade is sharp on one side and blunt on the other. The blade is attached to a plastic ring which slides over the blade assembly shaft, remove the blade to reverse edges, so it can be easily turned over to select the appropriate blade. To remove this blade twist in a counterclockwise motion. A guide for proper blade selection follows in the section, Frequent Uses for Chopper/Grinder (page 9.) Before you process any food, assemble the parts. 1. Place the prep bowl on a flat, dry, stable surface. 2. The metal blade assembly shaft is attached to the bottom of the prep bowl. If not already in place, slide the fully assembled F blade assembly over the top of the blade assembly shaft. K To put together the blade assem- N bly: Connect the blade ring (F) to the plastic blade sheath (G). Line up the G blade ring opening with the plastic sheath. Let the blade ring slide to the bottom of the plastic sheath. HOLD THE BLADE RING BY THE CENTRAL HUB HOLDING RIBS (grips) (K) ONLY. DO NOT TOUCH THE RAZOR-SHARP BLADES.