Cuisinart DGB-700BCFR DGB-700BC Manual - Page 8

CONTROL PANEL 1. On/Off button with LED Indicator a. Audible Tone The Fully Automatic Burr Grind & Brew™ Coffeemaker is equipped with an audible tone which will sound 5 times when the coffee has completed brewing (coffee may continue to stream from the filter for several seconds afterward). b. Auto Off The auto off feature is used to shut off the coffeemaker at a preset time, anywhere from 0 to 4 hours. 2. Hour and Minute Buttons Press and hold either Hour or Min for approximately 2 seconds to enter Time Set Mode. 3. Clock/LCD Display Displays time of day or Auto On time. Displays Strength Control setting (MILD, MED or STRONG). 4. Program Button with LED Indicator Press to display or set Auto On time. 5. Grind Off Button with LED Indicator Use to turn off the grinder when using pre-ground coffee. 6. Grind Control Knob Turn the Grind Control to choose the desired amount of coffee beans to grind. 7. Strength Control Button Press to choose coffee strength: mild, medium, or strong. Selected coffee strength will show on Clock Display. PROGRAMMING YOUR COFFEEMAKER Setting the Clock When the coffeemaker is plugged in, 12:00 will appear until you set the time. Entering Time Set Mode To set the time, hold down either the Hour or Minute button until the clock begins flashing (about 2 seconds). You are now in the Time Set mode and can operate either button to select the desired time. The buttons can be held down to scroll through the digits, or pressed and released to advance one digit at a time. When scrolling, the numbers will advance slowly at first and then speed up to the rate of about three per second. When the number displayed approaches the desired time, release the button and press repeatedly to advance one digit at a time. Be careful to make sure that the PM indicator is on if a PM time is desired. Exiting Time Set Mode The Time Set mode can be exited in one of two ways: 1. Press any button besides the Hour or Minute button. This will exit the Time Set mode and activate the selected function. 2. Do nothing. If neither the Hour or Minute button is pressed for a period of five seconds, the Time Set mode will be exited. Setting the Program Time When you press the Program Set button, it displays the current auto on time (default time 12:00 pm). Entering Set Program Time Mode Press and hold the Program Set button (about 2 seconds) until the green light and LCD display begin to flash. This signals that you have entered the Set Program Time mode. The