Cuisinart DLC-XPBC Instruction and Recipe Booklet - Page 7
Important, Practicing With Food
UPC - 086279012401
View all Cuisinart DLC-XPBC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
There are two levers on the base of the machine. They give you fingertip control of processing. For continuous processing, use the ON lever, at the left. Press it to start the motor. To turn the motor off, press the PULSE/ OFF lever at the right. Try it a few times. For rapid on-off operation called pulsing, use the PULSE/ OFF lever at the right. Press the lever down, then release it. The motor runs as long as you hold the lever down; it stops when you release the lever. Try it a few times. PRACTICING WITH FOOD After trying continuous operation with the ON lever and pulsing with the PULSE/OFF lever, practice with some food. A raw zucchini or potato is a good choice. Cut it in 2 inch (5 cm) pieces. Insert the metal blade and put the pieces in the work bowl. Put on the cover and the pusher assembly; press the pusher assembly down to lock it into place. Press and release the PULSE/OFF lever two or three times and see what happens. Each time the blade stops, let the pieces of food drop to the bottom of the bowl before you pulse again. This puts the food in the path of the blade each time the motor starts. Notice that you control pulsing. You control the duration of each pulse by the amount of time you hold the lever down. You control the frequency of pulses by the rate at which you press the lever. The interval between pulses must be long enough to allow everything in the work bowl to fall to the bottom. Pulsing gives you precise control over chopping, mincing, blending and mixing. You can process food to any texture or consistency you want, from coarse to fine. One of the most surprising things to new users is how fast the processor does its job. It takes a little practice to get used to its exceptional speed. Always use the PULSE/OFF lever for pulsing. Never move the pusher assembly on and off to control pulses. For your protection, the machine has a fast-stop circuit that operates as soon as the pusher assembly is unlocked. Rapid and repeated locking and unlocking of the pusher assembly will strain that circuit and damage the processor. Always turn the machine off with the PULSE/OFF lever and wait until the blade or disc comes to a complete stop before removing the pusher assembly. The motor stops within seconds after the machine has been turned off. IMPORTANT: To keep its powerful motor well ventilated, fans in the food processor base provide a stream of cooling air. To ensure proper ventilation of the motor during heavy use, place the machine so there are at least 4 inches of clear space on all sides. Using the on-off pulsing technique, you can get an even chop without danger of overprocessing. Check the texture frequently by looking through the cover of the work bowl. If you want a finer chop, press and release the PULSE/OFF lever until you achieve the desired texture. Onions and other food with a high water content will quickly end up as a purée unless examined through the cover of the work bowl after each pulse to make sure they are not overprocessed. Try chopping other food, like meat for hamburger or breakfast sausage. Refer to section on page 8, "Chopping and Puréeing Meat" for correct procedure. Some important factors in obtaining consistent results are: ᮣ The size of the pieces you add to the work bowl or through the feed tube. ᮣ The amount of food you process at one time. ᮣ The type of processing you choose - continuous or on-off pulsing. As in all food preparation, the quality of your results with the food processor depends on the freshness and quality of your ingredients. To become familiar with the operation of the slicing and shredding discs, try slicing an apple or shredding some carrots. Then make mayonnaise, pastry or bread, as described in the recipes at the end of this book. You will be surprised and delighted at how quickly and easily they all can be prepared with the food processor. 6