Cuisinart EM-400 Owner Manual - Page 8
Programming, A Custom Setting, Temperature, Controls, Energy-saver Mode, Auto-off Mode
View all Cuisinart EM-400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
2. With a coffee cup or mug on the drip tray, select COFFEE (approximately 6 ounces). (The coffee setting and, if applicable, the temperature setting LEDs remain on, while all the other LEDs are off. Once all LEDs are on again, the machine is ready for the next cycle.) CAUTION: Scalding may occur if the brewing head is opened during brewing cycle. Reminder: There is no need to rinse in-between cycles as there will be no transfer of flavor. See Espresso section NOTE on previous page. Manual/Adjustable Strength Control 1. Using the lever, open the brew head, insert a capsule, and close the brew head. 2. For adjustable strength control, use the MANUAL button to adjust the length of time espresso or coffee is dispensing - the longer you allow it to flow, the lighter it will be. Press to start dispensing. When your cup is filled to desired level, press again to stop. Manual function will time-out after 90 seconds. PROGRAMMING A CUSTOM SETTING At ready mode, press and hold MANUAL for 3 seconds to customize the SHORT , LONG and COFFEE output. 1. , , are flashing and is ON. If no action is taken within 30 seconds, unit returns to preheat/ready mode. 2. Press , or button. a. Chosen setting and LEDs remain on. b. Espresso/coffee is dispensed. c. When desired amount is dispensed into cup, press chosen setting again to stop. That will be the programmed amount and unit will return to preheat/ready mode. d. If no action is taken during dispensing within 90 seconds, unit returns to preheat/ ready mode. Setting will not be changed. To reset any setting to factory default (at ready mode), press and hold and chosen setting at the same time for 3 seconds. 1. or or and LEDs flash 3 times. 2. Default setting is on and unit will return to preheat/ready mode. TEMPERATURE CONTROLS Extra-hot is the default setting. If hot is desired, press and hold the button for 3 seconds to allow the temperature to decrease. The flashing light will turn off when it has reached the lower temperature. ENERGY-SAVER MODE After 30 minutes of non-use the espresso machine will automatically switch to sleep mode and all the control lights will be dimmed by about 50%. When any button is pressed, the espresso machine will return to preheat mode and all the lights will flash. The machine is ready to operate when all the lights are steady again. AUTO-OFF MODE Following the 30-minute Energy Saver cycle, if there is an additional 30 minutes of non-use, the espresso machine will turn off. Press the power button to turn on again. 7