Cuisinart FP-12BK FP-12DC Manual - Page 15

CLEANING AND STORAGE Keep your Cuisinart Elite Collection™ 12-Cup Food Processor ready to use on the kitchen counter. When not in use, leave it unplugged. Keep the blades and discs out of the reach of children. All parts except the housing base are dishwasher safe, and we recommend washing them in the dishwasher on the top rack only. Due to intense water heat, washing the work bowls, cover and accessories on the bottom rack may cause damage over time. Insert the cover with the feed tube facing up to ensure proper cleaning of the seal. (Note: The seal is not removable and water will drain properly.) Insert the work bowls and pushers upside down for drainage. Remember to unload the dishwasher carefully wherever you place sharp blades and discs. To simplify cleaning, rinse the work bowls, cover, pusher assembly and blade or disc immediately after use so food won't dry on them. Be sure to place the pushers upside down for drainage. If food lodges in the pusher, remove it by running water through it, or use a bottle brush. If you wash blades and discs by hand, do it carefully. When handling, use the plastic hubs on the blades and finger holes for the discs. Avoid leaving them in soapy water where they may disappear from sight. To clean the metal blade, fill the work bowl with soapy water, hold the blade by its plastic center and move it rapidly up and down on the center shaft of the bowl. Use of a spray attachment is also effective. If necessary, use a brush. The work bowls are made of polycarbonate plastic, which is shatter resistant and heat resistant. They should not be placed in a microwave oven, as the aperture at the front of the pusher houses the metal rod that activates the motor. The housing base may be wiped clean with a soapy, non-abrasive material. Be sure to dry once clean. Four rubber feet on the underside keep the base from moving on most work surfaces when the machine is processing heavy loads. If the feet leave spots on the counter, spray them with a spot remover and wipe with a damp sponge. If any trace of the spot remains, repeat the procedure and wipe the area with a damp sponge and nonabrasive cleaning powder. IMPORTANT: Never store any blade or disc on the motor shaft. No blade or disc should be placed on the shaft except when the processor is about to be used. FOR YOUR SAFETY Like all powerful electrical appliances, a food processor should be handled with care. Follow these guidelines to protect yourself and your family from misuse that could cause injury. Handle and store metal blades and discs carefully. Their cutting edges are very sharp. Always place the stem adapter on the motor shaft before assembling the discs. Never put blades or discs on the motor shaft until the work bowl is locked in place. Always be sure that the blade or disc is down on motor shaft as far as it will go. Always insert chopping blade and dough blade in the work bowl before putting ingredients in bowl. When slicing or shredding food, always use the pusher. Never put your fingers or spatula into feed tube. Always wait for the blade or disc to stop spinning before you remove the pusher assembly or cover from the work bowl. Always unplug the unit before removing food, cleaning, or putting on or taking off parts. Always remove work bowl from base of machine before you remove chopping blade or dough blade. TECHNICAL DATA The motor in your food processor operates on a standard line operating current. The appropriate voltage and frequency for your machine are shown on a label on the bottom of the base. An automatic, temperature-controlled circuit breaker in the motor ensures complete protection against motor burnout. If the processor runs for an exceptionally long time when chopping, mixing or kneading a thick or heavy mixture in successive batches, the motor may overheat. If this happens, the processor will stop. Turn it off and wait for the motor to cool before proceeding. It will usually cool within 10 minutes. In extreme cases, it could take an hour. Safety switches prevent the machine from operating when the work bowl or the cover is not locked into position. The motor stops within seconds when the motor is turned off, and when 15