Cuisinart FS-75 User Manual - Page 6
Use And Care, Cleaning And Maintenance, Technical Data
![]() |
View all Cuisinart FS-75 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
USE AND CARE 1. To use your Cuisinart® Food Slicer, place on a sturdy, flat surface. 2. Check that the switch is turned OFF before plugging in the appliance. 3. Adjust the slice control knob to desired slicing thickness (1/32" 0.8mm to ½" 15mm). 4. Position food to be cut on the stainless steel carriage and secure with plastic safety guard. 5. Turn the Cuisinart® Food Slicer ON. 6. Position hand on food guide handles and smoothly slide carriage backward and forward. NEVER USE YOUR FINGERS. 7. To ensure even slicing, do not press the food against the blade too firmly. 8. At this point, check for desired thickness and adjust accordingly with the slice control knob. 9. Continue to slide food carriage back and forth in an even and steady motion. NOTE: Food carriage is removable for cleaning. 10. After all your slicing is done, turn the slicer OFF and unplug. The Cuisinart® Food Slicer has been designed to operate for short periods (maximum 10 minutes). Do not run for more than 10 minutes in constant use. Allow it to cool before using it again. If the power cord is damaged, a service center recommended by the manufacturer must repair it. CLEANING AND MAINTENANCE Always unplug your Cuisinart® Food Slicer and turn the slice control knob back to zero before cleaning the appliance. DO NOT PUT THE APPLIANCE IN WATER. This could cause damage to electrical parts. 1. Clean and dry all parts immediately after use. 2. Fold out food carriage away from the base for easy cleaning of crumbs, seeds, etc. 3. To remove food carriage for cleaning, hold food carriage with two hands and tilt frontward toward you. There is a button to release the carriage marked "Press to release." Press, release, and wash with warm, soapy water. Dry thoroughly. To reassemble, align top part of food carriage to bottom part of food carriage and click into place. 4. To remove blade, press in tab where indicated in center hub; twist clockwise and carefully lift and remove blade. 5. With a soft sponge or cleaning cloth, clean both sides of blade with mild soap and water. Rinse and dry blade thoroughly. 6. To replace blade, hold tab, aligning the blade with the drive gears so it engages fully. Turn tab counterclockwise to tighten. 7. Any other servicing should be performed by an authorized service representative. DO NOT WASH ANY PART OF THIS SLICER IN A DISHWASHER. TECHNICAL DATA CARRIAGE SURFACE: Blade: POWER: Stainless Steel Stainless Steel 130W 120V/60Hz 6
![](/manual_guide/products/cuisinart-fs75-user-manual-028c4a1/6.png)