D-Link 5G/LTE Quick Install Guide - Page 3

ENGLISH STEP 2: Connect an Ethernet Cable to the PoE Port on the DWP-1010 Sealing Insert Mount the DWP-1010 to a Wall RJ-45 Gland Sealing Cap 1. Separate the sealing cap and sealing insert of the waterproof connector. 2. Insert the RJ-45 connector to the PoE port by threading an Ethernet cable through each in order: gland, sealing insert, and sealing cap. 3. Place the water-resistant component back to the DWP-1010. 4. Attach the sealing insert to the gland and make sure the assembly is fixed on the bottom of the water-resistant component. 5. Attach the sealing cap and tighten until snug. 6. Secure the water-resistant component with the six (M2.5x6 mm) screws. Position it with the aid of the arrow indicating the front side on the bottom. 7. Thread the RJ-45 cable through the protective base. 8. Reinstall the protective base with the four (M3x4 mm) screws. (Skip this step if wall mount will be used.) Mounting Mount the DWP-1010 to a Pole Use two stainless clamps to attach the DWP-1010 to a pole. Do not tighten firmly until the site survey is completed. (Refer to Connect the DWP-1010 to Your Network and Configuration.) To adjust the installation, loosen slightly and slide. Before fixing the DWP-1010 onto a wall, supply power to the device with the PoE Injector (refer to Connect the DWP-1010 to Your Network) and check the signal strength using the LED indicators (refer to Signal Strength). 1. Mark the mounting positions with a pencil following the above alignment guide. 2. Drill holes on the wall no wider than the anchor. 3. Hammer in the anchors until they are flush with the wall. 4. Align the protective base over the holes and secure it tightly with screws. 5. Reassemble the body of the DWP-1010 and the base. Secure them with the four (M3x4 mm) screws. 2 D-Link DWP-1010 Quick Install Guide