D-Link 809TC User Guide - Page 24
Cascading Hubs Through UTP, Cable
UPC - 790069200373
View all D-Link 809TC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Cascading Hubs Through UTP Cable Any of the UTP ports can be used to cascade hubs together. Note that when two UTP ports of two hubs are connected together, the wires inside the UTP cable must be crossed over. See appendix A for the wire cross-over. Mark all crossed-over UTP cables clearly so they will not be used by mistake for normal connection. If you use Mini Hub model DE-809TP, UTP port labeled "9" is especially designed for hub cascading. When this port is in the Uplink position, its signal reception and transmission are reversed. This allows you to dispense with the trouble of crossing the UTP cable's wires. Putting this port in the Uplink position can be done by pressing down the button located next to the port. Note: Never cause a loop when you cascade hubs since this might cause unpredictable results. 12 Installation