D-Link ANT24-0230 User Guide - Page 4

ASNysTte2m4-RSeeqruiieresments ANT24-0700 Install Guide Regulations D-Link WLAN Antenna-Kit Extended range differentiation for FCC/CE regulated regions CE ETSI EN 300 328 regulated European Union (EU) regions Based on ETSI EN 300 328, the system device and its antenna Emitted Isotropic Radiated Power (EIRP) are limited to operate within a 20dBm gain. The range extension provided by the antenna kit should comply with the restrictions set by the EU. FCC regulated regions (US, Canada, etc.) Using the same antenna-kit in FCC-regulated regions, the extended range may extend farther than CE-regulated antennas due to a higher output power allowance (FCC limits EIRP emissions to 36dBm). The usage of high gain antennas must be properly set to comply with EU regulations, and additional consideration should be made to avoid potential health hazard. Consult a professional installer for every occasion of application. Outdoor Installations To fully benefit from D-Link's extensive range of quality outdoor antennas, please note that they should be installed by a professional and must comply with the Europe Union CE wireless radio frequency output power. Cable length will affect the antenna gain dramatically. EIRP limitaton: ETSI point to multi-point point to point 2.4GHz~2.5GHz 20dBm ave. 23dBm peak. 5.15GHz~5.35GHz 5.47~5.725 23dBm 30dBm 5.75GHz~5.875GHz X FCC point to multi-point 36dBm point to point 30+6(antenna gain ) dBm then above 30dBm, one dB output power reduced, then 3dB antenna gain increased 23dBm 36dBm X 30+23(antenna gain) then above 30dBm, one dB output power reduced, then 3dB antenna gain increased Cable Loss Model ANT24-CB03N ANT24-CB06N ANT24-CB09N For outdoor use EIRP = Effective,Isotropic Radiated Power = Device Output Power + Antenna Gain - Cable Loss Cable Type LMR400 LMR400 LMR400 Length 3m 6m 9m Interface N plug to N jack N plug to N jack N plug to N jack Cable loss (dB) @ 2.4GHz 1 1.85 2.6 Cable loss(dB) @5GHz 1.75 2.7 3.8 Note: 1. The loss value includes two connectors ( around 0.3~0.4dB @ 2.4GHz, 0.39~0.52dB@5GHz). 2. The longer cable you use, the more attenuation it causes, therefore, the extended range might be shorten then a normal link with default cables. 3. To comply with EU regulation, please use longer cables which can cause enough attenuation value. 4. For more detail of connectors type, please refer to the appendix page.(P.30)