D-Link DFL-260E User Manual for DFL-260E - Page 245
Note: Optimal ATS handling, Decrement TTL, Dynamic CAM Size, CAM Size, L3 Cache Size
View all D-Link DFL-260E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 245 highlights
4.7.5. Advanced Settings for Transparent Mode Chapter 4. Routing Default: Enabled Decrement TTL Enable this if the TTL should be decremented each time a packet traverses the firewall in Transparent Mode. Default: Disabled Dynamic CAM Size This setting can be used to manually configure the size of the CAM table. Normally Dynamic is the preferred value to use. Default: Dynamic CAM Size If the Dynamic CAM Size setting is not enabled then this is the maximum number of entries in each CAM table. Default: 8192 Dynamic L3C Size Allocate the L3 Cache Size value dynamically. Default: Enabled L3 Cache Size This setting is used to manually configure the size of the Layer 3 Cache. Enabling Dynamic L3C Size is normally preferred. Default: Dynamic Transparency ATS Expire Defines the lifetime of an unanswered ARP Transaction State (ATS) entry in seconds. Valid values are 1-60 seconds. Default: 3 seconds Transparency ATS Size Defines the maximum total number of ARP Transaction State (ATS) entries. Valid values are 128-65536 entries. Default: 4096 Note: Optimal ATS handling Both Transparency ATS Expire and Transparency ATS Size can be used to adjust the ATS handling to be optimal in different environments. 245