D-Link DGE-560T Product Manual - Page 20

Configuration, Con your Adapter - vista

Get D-Link DGE-560T - Gigabit PCI-Express SNMP VLAN Flow Control Network Adapter PDF manuals and user guides
UPC - 790069273971
View all D-Link DGE-560T manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

Configure your Adapter After you install your new D-Link adapter, by default, the TCP/IP settings should be set to obtain an IP address from a DHCP server (i.e router) automatically. To verify your IP address, please see follow the steps below: Windows® 2000/XP: Click on Start > Run. In the run box type cmd and click OK. Windows Vista™: Click on Start > All Programs > Accessories > Command Prompt. At the prompt, type ipconfig and press Enter. This will display the IP address, subnet mask, and the default gateway of your adapter. If the address is 0.0.0.0, check your adapter installation, security settings, and the settings on your router. Some firewall software programs may block a DHCP request on newly installed adapters. D-Link DGE-560T User Manual 17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
D-Link DGE-560T User Manual
±µ
Configure your Adapter
After you install your new D-Link adapter, by default, the TCP/IP settings should be set to obtain an IP address from a DHCP server (i.e
router) automatically. To verify your IP address, please see follow the steps below:
Windows
®
2000/XP: Click on
Start
>
Run
. In the run box type
cmd
and click
OK
.
Windows Vista
™
: Click on
Start
>
All.Programs
>
Accessories
>
Command.Prompt
.
At the prompt, type
ipconfig
and press
Enter
.
This will display the IP address, subnet mask, and the default gateway of your adapter.
If the address is 0.0.0.0, check your adapter installation, security settings, and the settings on your router. Some firewall software programs
may block a DHCP request on newly installed adapters.