D-Link DGS-1510-20 User Manual - Page 18

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide • When AAA is enabled, the AAA module is used. • When AAA is disabled, the following rules are used: o When login is disabled, the username and password is ignored. Enter the details at Level 1. o When the username and password option is selected, use the username and password setup by the username command. o When the password option is selected, the username is ignored but a password is required using the password command to enter the line at level 1. Example This example shows how to enter the Line Configuration Mode and to create a password for the line user. This password only takes effect once the corresponding line is set to login. Switch# configure terminal Switch(config)# line console Switch(config-line)# password loginpassword Switch(config-line)# This example shows how to configure the line console login method as "login". Switch# configure terminal Switch(config)# line console Switch(config-line)# login Switch(config-line)# This example shows how to enter the login command. The device will check the validity of the user from the password create command. If correct, the user will have access at the particular level. Switch#login Password Switch# This example shows how to create a username "useraccount" with the password of "pass123" and use Privilege 12. Switch# configure terminal Switch(config)# username useraccount privilege 12 password 0 pass123 Switch(config)# This example shows how to configure the login method as login local. Switch# configure terminal Switch(config)# line console Switch(config-line)# login local Switch(config-line)# 2-7 logout This command is used to close an active terminal session by logging off the Switch. logout 15