D-Link DGS-1510-52 User Manual - Page 190

DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide After selecting the IGMP option as the Protocol Type, the following section will appear. Figure 8-12 ACL Configuration Wizard (Add Rule for IPv4 ACL) IGMP window The dynamic fields that can be configured are described below: Parameter Fragments Source Destination IP Precedence ToS DSCP Description Select the Fragments option to include packet fragment filtering. Select and enter the source information here. Options to choose from are Any, Host, and IP. When the Any option is selected, any source traffic will be evaluated according to the conditions of this rule. When the Host option is selected, enter the source host's IP address here. When the IP option is selected, the Wildcard option will also be available. Enter the group of source IP addresses by using a wildcard bitmap. The bit corresponding to the bit value 1 will be ignored. The bit corresponding to the bit value 0 will be checked. Select and enter the destination information here. Options to choose from are Any, Host, and IP. When the Any option is selected, any destination traffic will be evaluated according to the conditions of this rule. When the Host option is selected, enter the destination host's IP address here. When the IP option is selected, the Wildcard option will also be available. Enter the group of destination IP addresses by using a wildcard bitmap. The bit corresponding to the bit value 1 will be ignored. The bit corresponding to the bit value 0 will be checked. Select the IP precedence value used here. Options to choose from are 0 (routine), 1 (priority), 2, (immediate), 3 (flash), 4 (flash-override), 5 (critical), 6 (internet), and 7 (network). After selecting the IP precedence value, select the Type-of-Service (ToS) value that will be used here. Options to choose from are 0 (normal), 1 (min-monetary-cost), 2 (max-reliability), 3, 4 (maxthroughput), 5, 6, 7, 8 (min-delay), 9, 10, 11, 12, 13, 14, and 15. Select or enter the DSCP value used here. This value must be 182