D-Link DGS-3620-52P-EI Product Manual - Page 251
BGP Neighbor Timer Settings, L3 Features > BGP > BGP Neighbor > BGP Neighbor Timer Settings
View all D-Link DGS-3620-52P-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 251 highlights
xStack® DGS-3620 Series Managed Switch Web UI Reference Guide IP Address Click the radio button and use the drop-down menu to select the IP address of the BGP speaking neighbor. Peer Group Name Click the radio button and use the drop-down menu to select the name of the BGP peer group. EBGP Multihop (1-255) Enter the TTL of the BGP packet sent to the neighbor. Weight (0-65535) Enter a value for weight. The valid range is from 0 to 65535. If this is not specified, the routes learned through another BGP peer will have a default weight of 0. Routes sourced by the local router have a weight of 32768. It cannot be changed. Tick the Default check box to use the default weight value. Update Source Action Enter an interface to be used by BGP sessions for TCP connection. By default, this parameter is not set. Interface Name Enter the IP interface name used. Send community Use the drop-down menu to select Standard or None. This specifies the communities attribute to be sent to the BGP neighbor. Standard means only standard communities will be sent and None means no communities will be sent. The default value is Standard. Next Hop Self Enable or disable the next hop self attribute. By default, this setting is Disabled Soft Reconfiguration Inbound Enable or disable the inbound soft reconfiguration function. By default, this setting is Disabled. Remove Private AS If this setting is set to Enabled, the private AS number in the AS path attribute of the BGP update packets will be dropped. By default, the setting is Disabled. Allow AS in If this is Enabled, the BGP router's self AS is allowed in the AS path list. By default, this setting is Disabled. If no number is supplied, the default value of three times is used. Allow AS in Value (110) Enter an Allow AS in Value between 1 and 10. Default Originate State Enable or disable the default originate function. By default, this setting is Disabled. Route Map Name Enter a Route Map Name of a maximum of 16 characters. Click the Apply button to accept the changes made. BGP Neighbor Timer Settings This window is used to configure BGP neighbor timer settings. To view the following window, click L3 Features > BGP > BGP Neighbor > BGP Neighbor Timer Settings, as shown below: Figure 5-125 BGP Neighbor Timer Settings window 241