D-Link DGS-3620-52P-SE-LIC Reference Guide - Page 231
PIM for IPv6 Candidate BSR Settings
View all D-Link DGS-3620-52P-SE-LIC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 231 highlights
xStack® DGS-3620 Series Managed Switch Web UI Reference Guide BSR Domain Border Use the drop-down menu to enable or disable the interface to be a PIM for IPv6 domain border. If this interface configures a border, which will prevent bootstrap router (BSR) messages from being sent or received through it. By default, an interface is not PIM for IPv6 domain border. Stub Interface Use the drop-down menu to enable or disabler this interface to be a STUB interface. If this interface configures a stub interface, then no PIM for IPv6 packets are sent out this interface, and any received PIM for IPv6 packets are ignored. By default, an interface is not stub interface. Click the PIM > PIM for IPv6 > PIM for IPv6 Candidate BSR Settings, as shown below: Figure 5-95 PIM for IPv6 Candidate BSR Settings window The fields that can be configured are described below: Parameter Description Interface Name Enter the IP interface used in this configuration. State Use the drop-down menu to enable or disable the input interface as a Candidate BSR. Priority (0-255) Enter the Candidate BSR priority value. Hash Mask Len (0-128) Enter the length (in bits) of the mask. It makes use of a hash function for the case where a group range has multiple RPs with the same priority. Click the Apply button to accept the changes made. PIM for IPv6 Candidate RP Settings This window is used to set the candidate rendezvous point (RP) related parameters. To view the following window, click L3 Features > IP Multicast Routing Protocol > PIM > PIM for IPv6 > PIM for IPv6 Candidate RP Settings, as shown below: 221