D-Link DGS-3630-52PC Manual - Page 55

DGS-3630 Layer 3 Stackable Managed Switch CLI Reference Guide Command Default Level Level: 12. Usage Guideline Only one access list of the same type can be applied to the same interface, but access lists of different types can be applied to the same interface. The association of an access group with an interface will consume the filtering entry resource in the switch controller. If the resource is insufficient to commit the command, then an error message will be displayed. There is a limitation on the number of port operator resources. If applying the command exhausts the available port selectors, then an error message will be displayed. Example This example shows how to specify the IPv6 access list "ip6-control" as an IP access group for ethernet 1/0/3. Switch#configure terminal Switch(config)#interface ethernet 1/0/3 Switch(config-if)#ipv6 access-group ip6-control in The remaining applicable IPv6 related access entries are 448, remaining range entries are 32. Switch(config-if)# 4-10 ipv6 access-list This command is used to create or modify an IPv6 access list. This command will enter into IPv6 access-list configuration mode. Use the no form of this command to remove an IPv6 access list. ipv6 access-list [extended] NAME [NUMBER] no ipv6 access-list [extended] {NAME | NUMBER} Parameters extended NAME NUMBER (Optional) Specifies that the IPv6 access list is the extended IPv6 access list, and more fields can be chosen for the filter. If the parameter is not specified, the IPv6 access list is the standard IPv6 access list. Specifies the name of the IPv6 access list to be configured. The maximum length is 32 characters. Specifies the ID number of the IPv6 access list. For standard IPv6 access lists, this value is from 11000 to 12999. For extended IPv6 access lists, this value is from 13000 to 14999. Default None. Command Mode Global Configuration Mode. Command Default Level Level: 12. 50