D-Link DGS-3630-52TC Manual - Page 200

DGS-3630 Layer 3 Stackable Managed Switch CLI Reference Guide A route map entry can contain multiple match and set statements. To match a route against a route map entry, all of the match statements in the route map rule must be satisfied. When a route map entry is matched, all the set statements in the rule will be performed. Use the match as-path command to match an access list in a route map entry. To match a route map entry, all match statements must be satisfied. To match an AS path access list, if an entry in the access list matches the route, then no further check will be done against the remaining entries in the access list. If the matched entry is a permit entry, then the AS path access list is matched. If the matched entry is a deny entry, then the AS path access list is not matched. If none of the rule entries match the route, then the AS path access list is not matched. Example This example shows how to add a match statement to the policy routing entry named "myPolicy". Switch# configure terminal Switch(config)# route-map myPolicy permit 1 Switch(config-route-map)# match as-path PATH_ACL 12-40 match community (MI and EI Mode Only) This command is used to define a BGP community access list match condition in a route map rule. Use the no form of this command to delete the match statement. match community COMMUNITY-LIST-NAME [exact] no match community Parameters COMMUNITY-LIST-NAME exact Specifies a BGP community access list. (Optional) Specifies that an exact match is required. All of the communities and only those communities specified must be present. Default No match statements in the route map. Command Mode Route-map Configuration Mode. Command Default Level Level: 12. Usage Guideline A route map can contain multiple route map entries, which is either a permit entry or a deny entry. When a route is checked against a route map, the entry in the route map will be checked whether match the route based on its sequence number in the route map. If an entry is found matched, the action associated with the entry will be taken and no further check will be done against the remaining entry in the route map. A route map entry can contain multiple match and set statements. To match a route map entry, all of the match statements in the route map rule must be satisfied. When a route map entry is matched, all the set statements in the rule will be performed. Use the match community command to match a community list in a route map entry definition. To match a route against a route map entry, all match statements must be satisfied. To match a community list, if an entry in the community list matches the route, then no further check will be done against the remaining entries in the access list. If the matched entry is a permit entry, then the community list is matched. If the matched entry is a deny entry, then 195