D-Link DGS-3630-52TC User Manual - Page 1286

DGS-3630 Layer 3 Stackable Managed Switch CLI Reference Guide Switch# configure terminal Switch(config)# class-map match-all gold Switch(config-cmap)# match cos 6 Switch(config-cmap)# exit Switch(config)# class-map match-all silver Switch(config-cmap)# match cos 5 Switch(config-cmap)# exit Switch(config)# class-map match-all bronze Switch(config-cmap)# match cos 0 Switch(config-cmap)# exit Switch(config)# policy-map cust1-classes Switch(config-pmap)# class gold Switch(config-pmap-c)# police 800 2000 exceed-action set-dscp-transmit 0 Switch(config-pmap-c)# exit Switch(config-pmap)# class silver Switch(config-pmap-c)# police 2000 2000 exceed-action set-dscp-transmit 0 Switch(config-pmap-c)# exit Switch(config-pmap)# class bronze Switch(config-pmap-c)# police 8000 2000 exceed-action set-dscp-transmit 0 Switch(config-pmap-c)# exit Switch(config-pmap)# exit Switch(config)# interface ethernet 1/0/1 Switch(config-if)# service-policy input cust1-classes Switch(config-if)# exit Switch(config)# interface ethernet 1/0/2 Switch(config-if)# service-policy input cust1-classes Switch(config-if)# 96-21 set This command is used to configure the new precedence field, DSCP field, and CoS field of the outgoing packet. The user can also specify the CoS queue for the packet. set {[ip] precedence PRECEDENCE | [ip] dscp DSCP | cos COS | cos-queue COS-QUEUE} no set {[ip] precedence PRECEDENCE | [ip] dscp DSCP | cos COS | cos-queue COS-QUEUE} Parameters precedence PRECEDENCE Specifies a new precedence for the packet. The range is from 0 to 7. If the optional keyword ip is specified, IPv4 precedence will be marked. If not specified, both IPv4 and IPv6 precedence will be marked. For IPv6 packets, the precedence is the most three significant bits of traffic class of IPv6 header. Setting the precedence will not affect the CoS queue selection. dscp DSCP Specifies a new DSCP for the packet. The range is from 0 to 63. If the optional keyword ip is specified, IPv4 DSCP will be marked. If not specified, both IPv4 and IPv6 DSCP will be marked. Setting DSCP will not affect the CoS queue selection. cos COS Specifies to assign a new CoS value to the packet. The range is from 0 to 7. Setting CoS will not affect the CoS queue selection. cos-queue COS-QUEUE Specifies to assign the CoS queue to the packets. This overwrites the original CoS queue selection. Setting the CoS queue will not take effect if the policy map is applied for the egress flow on the interface. Default None. 1281