D-Link DIR-859 User Manual - Page 59
IPv4/IPv6 Rules
View all D-Link DIR-859 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
Section 3 - Configuration IPv4/IPv6 Rules The IPv4/IPv6 Rules section allows you to specify the kind of traffic that is allowed to pass through the network. For IPv4 rules, from the Firewall Settings page click IPv4 Rules. For IPv6 rules, from the Firewall Settings page click IPv6 Rules. Use the drop-down menu to select whether you want to Turn IPv4 Filtering ON and ALLOW or DENY the rules you create. Or you may choose to Turn IPv4 Fltering OFF. If you wish to remove a rule, click on its trash can icon in the Delete column. If you wish to edit a rule, click on its pencil icon in the Edit column. If you wish to create a new rule, click Add Rule. Click Save when you are done. When you click on Add Rule, the Create New Rule window will open. Enter the required information into the fields described below: Name: Enter a Name for the new rule. Source IP Enter the Source IP Address Range that the rule applies to. Using Address Range: the drop-down menu, specify whether it is a WAN or LAN IP address. Destination IP Enter the Destination IP Address Range that the rule applies to. Address Range: Using the drop-down menu, specify whether it is a WAN or LAN IP address. Port Range: Select the protocol of the traffic to allow or deny (Any, TCP, or UDP) and then enter the range of ports that the rule will apply to. Schedule: Use the drop-down menu to select a Schedule when the rule will be enabled. The schedule may be set to Always Enable, or you can create a schedule from the Schedules section (refer to page 64). Click Apply when you are done. D-Link DIR-859 User Manual 55