D-Link DSL-302G Installation Guide - Page 5
Ethernet Installation - d link driver
View all D-Link DSL-302G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Click Finish to reboot the computer After the computer restarts, the USB drivers should now be installed. Please proceed to step to configure the DSL-302G. Ethernet Installation (for all Operating Systems) Connect the DSL-302G to a suitable power source. Once the unit is powered on, insert one end of the included Ethernet cable into the Ethernet port, and the other end into the Ethernet port of the NIC card installed on your computer. Make sure your computer is turned on. Note: If the cable connection is good, a green LED on the front of the device labeled Ethernet/Link will glow steadily.
After the computer restarts, the USB drivers should now be installed.
Please proceed to step
to configure the DSL-302G.
Ethernet Installation
(for all Operating Systems)
Connect the DSL-302G to a suitable power source.
Once the unit is powered on, insert one end of the
included Ethernet cable into the Ethernet port, and the
other end into the Ethernet port of the NIC card installed
on your computer. Make sure your computer is turned
on.
Note:
If the cable connection is good, a green LED on the front of the device labeled
Ethernet/Link will glow steadily.
Click
Finish
to reboot
the computer