D-Link DXS-3600-32S CLI Guide - Page 19

Usage Guideline DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide Under port-based mode, use the parameter interface to initialize a specific port. Under host-based mode, use the parameter mac-address to initialize a specific MAC address. Example This example shows how to initialize the authenticator state machine on Ethernet port 1. DXS-3600-32S#configure terminal DXS-3600-32S(config)#dot1x initialize interface tenGigabitEthernet 1/0/1 DXS-3600-32S(config)# 2-10 dot1x system-auth-control This command is used to globally enable IEEE 802.1X authentication on the switch. Use the no form of this command to disable IEEE 802.1X function. dot1x system-auth-control no dot1x system-auth-control Parameters Default Command Mode Command Default Level Usage Guideline None. 802.1X is disabled globally by default. Global Configuration Mode. Level: 8 Use this command to enable 802.1X authentication globally. Example This example shows how to enable IEEE 802.1X authentication on the switch. DXS-3600-32S#configure terminal DXS-3600-32S(config)#dot1x system-auth-control DXS-3600-32S(config)# 2-11 dot1x system-max-user This command is used to configure the maximum number of users that can be learned via 802.1X authentication. Use the no form of this command to reset to the defaulting settings. dot1x system-max-user no dot1x system-max-user Parameters Specifies the maximum number of users. Default Command Mode Command Default Level Usage Guideline By default, the maximum number of users that can be learned via 802.1X authentication is 4096. Global Configuration Mode. Level: 8 The setting is a global limitation on the maximum number of users that can be learned via 802.1X authentication. In addition to the global limitation, the maximum number of users per port is also limited. 11