D-Link DXS-3600-EM-8XS CLI Guide - Page 396

DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide Example This example shows how to remove the authentication on System interface (VLAN 1). DXS-3600-32S#configure terminal DXS-3600-32S(config)#interface vlan 1 DXS-3600-32S(config-if)#no ip ospf authentication DXS-3600-32S(config-if)# 40-13 ip ospf authentication-key This command is used to configure the plain text authentication key for an OSPF interface. Use the no command to delete the plain text authentication key. ip ospf authentication-key password no ip ospf authentication-key Parameters password Specifies up to 8 bytes for the plain text authentication key. The syntax is general string that does not allow space. Default Command Mode Command Default Level Usage Guideline By default no key is configured. Interface Configuration Mode. Level: 8. (EI Mode Only Command) This command creates a password (key) that is inserted into the OSPF header when the router originates routing protocol packets. Assign a separate password to each network for different interfaces. Routers on the same network must use the same password to be able to exchange OSPF routing data. Use the ip ospf authentication command to enable authentication. Configure the routers in the same routing domain with the same password. Users can verify the settings by entering the show ip ospf interface command. Example This example shows how to set the System interface (VLAN 1) authentication type to simple password. DXS-3600-32S#configure terminal DXS-3600-32S(config)#interface vlan 1 DXS-3600-32S(config-if)#ip ospf authentication DXS-3600-32S(config-if)#ip ospf authentication-key yourpass DXS-3600-32S(config-if)# 40-14 ip ospf cost This command is used to configure the cost of sending a packet on an OSPF interface. Use the no command to restore to the default value. ip ospf cost cost no ip ospf cost Parameters cost Specifies the OSPF interface cost. The value range is 1 to 65535. 388