DELPHI SA10162 Installation Guide - Page 8
SKYFi2 Vehicle Adaptor after
View all DELPHI SA10162 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
8 c. Swivel mount: This mount allows you to adjust the angle of your SKYFi2 Vehicle Adaptor after it is installed. This mount uses a strong adhesive that is not eas- ily repositioned when installed, so use care when choosing the location of and placing the mount. Do not install this mount on a leather surface. Install the mount only if the temperature is at least 60°F. - Clean the mounting surface with the enclosed surface preparation cleaning kit. Wipe the towelette in one direction only. Do not wipe the surface in a circular motion or back and forth. Dry the area with a clean, dry cloth. Repeat the cleaning process. Allow to air dry thoroughly. - Clean the same surface with the enclosed alcohol prep pad. Wipe in one direction only. Dry the area with a clean, dry cloth. Allow to air dry thoroughly. - Warm the vehicle mount adhesive pad by using a hair dryer or by placing the vehicle mount on top of the vehicle's defrost outlet for several minutes with the heater on. Remove the liner from the adhesive pad and adhere to the vehicle's surface. Make sure you accurately place the pad on the first try since in many cases it will bond almost immediately. For best results, do not touch or apply pressure to the vehicle mount for 72 hours.