Dacor DCT305 Use & Care Manuals - Page 7

Setting Up Your Cooktop Burner Assembly warning Never attempt to operate the cooktop with any of the burner parts removed. Assemble the burners and grates only when the cooktop is cool. SimmerSear Burner 1. Install the SimmerSear burner ring on the SimerSear burner base (located on the center of the cooktop). Line up the indentations on the bottom of the burner ring with the pins on top of the burner base. 2. Set the outer SimmerSear burner cap on top of the burner ring. Make sure it is centered on top. 3. Set the inner SimmerSear burner cap on the center of the burner base. Line up the ridge on the bottom of the cap with the pins on the center of the burner base. Standard Burners 1. Install the standard burner rings on the standard burner bases (match sizes). Put the holes on the edge of each ring over the igniter. Center the tabs on the bottom of each ring in the hole in the center of each base. 2. Install all the standard burner caps. The ridge on the bottom of each cap must surround the top of each ring. On model DCT305, the left rear burner cap has tabs on the bottom that fit into the slots on the top of the burner ring. continued... Ridge on bottom of burner cap Igniter hole Burner ring, top view Ridge on bottom Inner burner cap Outer burner cap Igniter CAUTION: Top of igniter is sharp! Burner ring Pin on burner base Burner base Standard Burner Assembly Tabs on bottom of burner cap Burner ring, top view SimmerSear Burner Assembly (Center Burner) Burner base Igniter Igniter hole CAUTION: Top of igniter is sharp! Left Rear Standard Burner Assembly on DCT305 5