Dacor DHI361 Installation Instructions - Page 12
Verifying Proper Operation, Installation Checklist
View all Dacor DHI361 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Installation Instructions Verifying Proper Operation Installation Checklist 1. Make sure power is switched on at the circuit breaker panel or fuse box. 2. If the control panel is not lit, remove the filter(s) and turn on the main power switch located behind the filters on the underside of the hood. Replace the filter(s). 3. Touch the light key. Verify that all the lights come on. 4. Touch the light key again to turn the lights off. 5. Touch the blower "+" key once and release. Verify that one light is showing on the blower speed indicator and that the blower is on at low speed. 6. Touch and release the blower "+" repeatedly, three times. Verify that with each touch of the key the number of lights on the speed indicator increases and that the blower speed increases accordingly. 7. Touch and hold the blower "-" key until the blower turns off. If the hood fails to operate properly: ■■ Verify that power is supplied to the hood. ■■ Check the electrical connections to ensure that the installation has been completed correctly. ■■ Repeat the above test. ■■ If the hood still does not work, contact Dacor Distinctive Service at (877) 337-3226. Do not attempt to repair the appliance yourself. If you need service, be sure to have the model and serial numbers available when you call. See the inside cover for location. Dacor is not responsible for the cost of correcting problems caused by a faulty installation. warning • To ensure a safe and proper installation, the following checklist should be completed by the installer to ensure that no part of the installation has been overlooked. • Proper installation is the responsibility of the homeowner. The importance of proper installation of your Dacor range hood cannot be overemphasized. □□ Is the mounting bracket properly attached to the ceiling according to the instructions on page 6? □□ Is the hood properly secured to the mounting bracket with the machine screws? See page 9. □□ Is the duct work completely installed? Are all joints attached with sheet metal screws and wrapped with duct tape? See pages 4, 5 and 9? □□ Is the range hood wired and grounded according to these instructions and in accordance with all applicable electrical codes? See pages 3 and 10. □□ Are the filters properly installed according to the use and care manual? □□ Has proper operation been verified? □□ Has the warranty been activated on-line or the war- ranty card filled out completely and mailed? 10