Dacor DR30EI Combined Configuration - Page 1

Document # PGCI-027 COMBINATION INSTALLATIONS DR30EI[F]S Range with ERV3015 Raised Vent Revised 10/15/12 Page 1/1 PLANNING GUIDE All tolerances +1/16" (+1.6 mm), -0 unless otherwise noted. ■■ Only models DR30EIS and DR30EIFS may be installed with a raised vent. Use only Dacor raised vent model ERV3015. ■■ A self-rimming countertop configuration is required for raised vent installation. On installations with a raised vent, when sliding the range into position, it will stop when the rear of the control panel or side panels contact the notches toward the front of the countertop. ■■ The self-rimming installation of the DR30DI range and ERV3015 raised vent create a "built-in" look where the range trim overlaps the countertop on both sides and the raised vent overlaps the countertop in back. Countertop height: 34 3/4" (88.3 cm) min. 36 7/8" (93.7 cm) max. Countertop thickness: 1 5/8" (4.1 cm) max. 25 9/16" (64.9 cm) 3/8" min. (1.0 cm) flat countertop overhang Range trim resting on countertop 10" min. (25.4 cm) to any combustibles above counter both sides Rear wall or 3/8" min. (1.0 cm) countertop edge countertop overhang Countertop 27 1/2" (69.9 cm) raised vent opening 24 3/8" (61.9 cm) max. Countertop front 29 1/4" (74.3 cm) countertop opening 30 1/16" (76.2 cm) cabinet opening below countertop Notch countertop to width of cabinets Cabinet face below countertop 2 5/8" (6.7 cm) 19 3/4" 19 3/4" (50.2 cm) (50.2 cm) to 22 3/4" (57.8 cm) ERV3015 raised vent 3/8" min. (1.0 cm) space required behind ERV3015 chassis to clear stiffener DR30EI[F]S range Top View - Downdraft ERV30[15] with Slide-In, Self-Rimming Installation using 3" Side Panels Installed 10" min. (25.4 cm) to any combustibles above counter both sides Rear wall or 3/8" min. (1.0 cm) countertop edge countertop overhang 25 9/16" (64.9 cm) 3/8" min. (1.0 cm) flat countertop overhang Range trim resting on countertop 27 1/2" (69.9 cm) raised vent opening 2 5/8" (6.7 cm) Countertop Cabinet face Back of side panel rests against cabinet face 3 inch side panel 24 3/8" (61.9 cm) max. Countertop front 29 1/4" (74.3 cm) countertop opening 30 1/16" (76.2 cm)* cabinet opening below countertop Notch countertop to width of cabinets Cabinet face below countertop 22 3/4" (57.8 cm) ERV3015 raised vent 3/8" min. (1.0 cm) space required behind ERV3015 chassis to clear stiffener DR30EI[F]S range Cabinet face Top View - Downdraft ERV30[15] with Slide-In, Self-Rimming Installation using 3" Side Panels Removed * To create a "built-in look" on the front of the cabinet, this dimension may be changed to 29 1/4" (74.3 cm), with the width at the notches remaining 30 1/16". This configuration is only for models DR30EIS and DR30EIFS with side panels behind door removed. All specifications subject to change without notice. www.dacor.com Phone: (800) 793-0093