Dacor DYWS4 Reference Guides - Page 2

Wine Dispensing System STEP 4 STEP 5 Open the door on the front of the system. Swing the spout cover to the up position. Spout cover Make sure the power switch, located on the left side of the bottle bay, is slid all the way down, to the OFF position. ON SERVICE MODE RESERVED OFF STEP 6 Find the gas regulator assembly that comes with the system. Make sure the regulator adjustment knob is turned all the way in the OFF direction. STEP 7 Connect the gas supply line from the wine dispensing system to the gas connector on the regulator assembly. STEP 8 Remove the plastic cap from the top of the argon gas cylinder.* STEP 9 Insert the top of the gas cylinder into the bottom of the gas regulator assembly and turn it clockwise, by hand, until it is snug. Do not use a wrench or overtighten. STEP 10 Turn the regulator knob in the ON direction until it stops. Regulator adjustment knob Argon gas cylinder Regulator assembly Gas supply line from wine dispensing system *IMPORTANT: The required argon gas cylinder is not shipped with the system and must be ordered separately. Order on-line at www. everythingdacor.com or by calling Dacor Customer Service at (800) 793-0093 ex. 2822. Your first gas argon gas cylinder is provided free of charge. STEP 11 Plug the power cord into the grounded 120 Vac., 60 Hz. electrical outlet. STEP 12 Slide the power switch all the way up to the ON position. When powering on, the system will run through a series of diagnostics, which will take several seconds. If the control panel is locked, perform the following steps: • Slide the power switch down one notch to the SERVICE MODE position (see diagram at top of page). • Push WineStation Service next to any of the displays. • Push Exit. • Slide the power switch up to the ON position. Page 2