Dacor ECS130SCH Use and Care Guide - Page 18

Problem Solution Guide - touch panel problems

Page 18 highlights

Problem Solution Guide Unnecessary service calls may be expensive, frustrating and time-consuming. Before you call for service, please review the potential problems, possible causes and remedies shown below. Also, see the facing page for various oven failure codes that can be displayed on the control panel. Failure codes wilt appear where the temperature is normally displayed on the control panel. Nothing works. Oven will not heat. Clock displays incorrect time of day. Foods over-cook. Foods under-cook. Oven does not self-clean. Oven light wilt not work. Door will not open. Oven is not connected to electrical power. Have oven connected to a properly sized electrical power supply by a qualified electrician. Power supply is not energized. Check for tripped circuit breaker or blown fuse. Have an electrician check power supply. Oven settings are not correct. Follow mode selection and clock settings as specified in OVEN OPERATION section. Oven is set for delay-timed cooking. Oven will turn on automatically at time set. If desired, press CANCEL • SECURE key to cancel out of delay timed cooking. Time of day is not set. Power supply has been interrupted. Press CLOCK touch pad, then press TIME • TEMP + or TIME ° TEMP - key to set correct time of day. Reset time of day. Incorrect cooking time, temperature or rack Adjust temperature or time settings. position being used. Oven temperature calibration differs from your previous oven. Incorrect cooking time, temperature orrack position being used. Oven temperatu_ calibration differs from your p_vious oven. Door is not shut tight so automatic door latch wilt not lock. Oven settings are not correct. Oven is set for delay timed cleaning. Light bulb is burned out. Oven is in self-clean mode. Oven is set to self-clean in delay-timed mode. Calibrate temperature according to Adjusting the Oven Temperature section (see Care and Cleaning). Adjust temperature or time settings. Calibrate temperature according to Adjusting the Oven Temperature section (see Care and Cleaning). Close door tightly. Follow mode selection and clock settings as specified in the Self-Cleaning section (see Care and Cleaning). Oven will turn on automatically at time set. If desired, press CANCEL ° SECURE key to cancel out delay-timed cleaning. Follow Replacing the Oven Light section (see Care and Cleaning). If oven is hot, door latch wilt release automatically when oven temperature falls below 390°F at end of cycle. If SELF-CLEAN was just selected and the oven is still cool, press CANCEL • SECURE key to turn off self-clean. The door will open in about 30 seconds. Oven will turn on automatically at time set. If desired, press CANCEL • SECURE key to cancel out of delay-timed mode. 16

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24

Problem Solution Guide
Unnecessary
service
calls may be expensive,
frustrating
and time-consuming.
Before you call for service,
please review
the potential
problems,
possible
causes and remedies
shown below. Also, see the facing page for various
oven failure
codes that can be displayed
on the control
panel. Failure codes wilt appear
where the temperature
is normally
displayed
on the control panel.
Nothing works.
Oven
will not heat.
Clock displays
incorrect
time of day.
Foods over-cook.
Oven is not connected
to electrical
power.
Power supply
is not energized.
Oven settings
are not correct.
Oven is set for delay-timed
cooking.
Time of day is not set.
Power supply
has been interrupted.
Incorrect
cooking
time, temperature
or rack
position
being used.
Oven temperature
calibration
differs from
your previous
oven.
Incorrect
cooking
time, temperature
orrack
position
being used.
Oven temperatu_
calibration
differs from
your p_vious
oven.
Door is not shut tight so automatic
door
latch wilt not lock.
Oven settings
are not correct.
Oven is set for delay
timed cleaning.
Foods under-cook.
Oven does not self-clean.
Oven light wilt not work.
Light bulb is burned
out.
Door will not open.
Oven is in self-clean
mode.
Oven is set to self-clean
in delay-timed
mode.
Have oven connected
to a properly
sized
electrical
power supply
by a qualified
electrician.
Check for tripped circuit breaker
or blown
fuse. Have an electrician
check
power
supply.
Follow mode selection
and clock settings
as specified
in
OVEN OPERATION
section.
Oven will turn on automatically
at time set.
If desired,
press CANCEL
• SECURE
key
to cancel out of delay timed cooking.
Press CLOCK
touch pad, then press
TIME • TEMP
+ or TIME
°
TEMP
- key to
set correct time of day.
Reset time of day.
Adjust temperature
or time settings.
Calibrate
temperature
according
to
Adjusting
the Oven
Temperature
section
(see
Care and Cleaning).
Adjust temperature
or time settings.
Calibrate
temperature
according
to
Adjusting
the
Oven
Temperature
section
(see
Care and Cleaning).
Close door tightly.
Follow mode selection
and clock settings
as specified
in the
Self-Cleaning
section
(see
Care and
Cleaning).
Oven will turn on automatically
at time set.
If desired,
press CANCEL
°
SECURE
key
to cancel out delay-timed
cleaning.
Follow
Replacing
the Oven
Light
section
(see
Care and
Cleaning).
If oven is hot, door latch wilt release
automatically
when
oven temperature
falls
below
390°F at end of cycle.
If
SELF-CLEAN
was just selected
and
the oven is still cool, press CANCEL
SECURE
key to turn off self-clean.
The
door will open in about 30 seconds.
Oven will turn on automatically
at time set.
If desired,
press CANCEL
SECURE
key
to cancel out of delay-timed
mode.
16