Dacor EF48DBSS Installation Instructions - Page 23

Installation Instructions Complete Installation 1. Turn the water supply line valve to the "Open" position. 2. Turn the refrigerator switch to the ON position. See Power On/ Off Switch in the use and care manual for instructions. Wait a few minutes. Check the water line connections for leaks. 3. Remove all boxes, parts packages and packing materials from the interior of the refrigerator. See the Care and Cleaning section in the use and care manual for instructions. Remove the film and cardboard from the grille and doors or door frame, depending on your model. 4. Install the shelves and bins in the refrigerator and freezer compartments. 5. The controls are preset at the factory to the midpoint setting. Check that the compressor is operating properly and that all the lights are working. 6. Flush the water system before use. See Water System Preparation. To get the most efficient use from your new built-in refrigerator, read your use and care manual. Keep Installation Instructions and the use and care manual near the refrigerator for easy reference. Water System Preparation Please read before using the water system. Immediately after installation, follow the steps below to make sure that the water system is properly cleaned. Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts. NOTE: If your model has a base grille filter system, make sure the base grille filter is properly installed and the cap is in the horizontal position. 2. Dispenser models: Use a sturdy container to depress and hold the water dispenser lever for 5 seconds, then release it for 5 seconds. Repeat until water begins to flow. Once water begins to flow, continue depressing and releasing the dispenser lever (5 seconds on, 5 seconds off) until a total of 3 gal. (12L) has been dispensed. Additional flushing may be required in some households. NOTE: As air is cleared from the system, water may spurt out of the dispenser. 3. Open the freezer door and turn on the ice maker. For nondispenser models, lower the wire shutoff arm. For dispenser models, move the switch to the ON (left) position. ƒƒ Allow 24 hours to produce the first batch of ice. ƒƒ Before using the ice, fill and discard two containers of ice to prepare the filter for use. ƒƒ Depending on your model, you may want to select the maximum ice feature to increase the production of ice. Any questions or problems with this installation should be directed to your Dacor dealer or the Dacor Customer Service Team at (800) 793-0093 or visit our web site at www.Dacor.com. If you need service, be sure to have the model and serial numbers when you call. You'll find these numbers on the serial number plate, located on the right hand side of the fresh food compartment. 1. Open the freezer door and turn off the ice maker. For non-dispenser models, lift up the ice maker cover, then, lift up the wire shutoff arm as shown. Ice maker cover Non-Dispenser Models For dispenser models, move the switch to the OFF (right) setting as shown. The On/Off switch is located on the top right side of the freezer compartment. Ice Maker Dispenser Models 21