Dacor EO130 Use & Care Manuals - Page 33

Care and Cleaning Installing your oven's filter(s): Cleaning the Accessories • The metal clips on the back of the filter hook over the metal bar across the fan hole. Place the filter flat IMPORTANT: You must remove all accessories from the against the back of oven above the hole with the clips oven during the self-clean cycle. If you leave accessories on the back of the filter pointing down. Be careful in the oven during self-cleaning, they will permanently not to push the filter too hard against the back wall discolor and/or become permanently damaged. Racks will because the clips can scratch the surface. Gently push become difficult to slide. the filter straight down over the hole until the clips catch on the metal bar. Oven Racks • To clean the oven racks, apply a solution of detergent and hot water. When you need to clean heavy soil, use a scouring pad such as steel wool with plenty of water. You may also use a solution of 1 cup of ammonia to 2 gallons of water. Filter Meat Probe Metal bar Fan hole on back of oven wall Clips on back of filter Replacing The Convection Filter IMPORTANT: Do not immerse the meat probe in water. It will become damaged. • The meat probe is constructed of vinyl handles, a wire, a plug, and a stainless steel skewer. To clean the skewer, use a scouring pad and hot, soapy water. When you clean the handles, wipe with soft sponge soaked with a solution of detergent and warm water. Clearing the "Clean Convection Fan Filter" Message: NOTE: The "Clean Convection Fan Filter" is a reminder that you should clean the convection filter(s). • Following the steps below, you may either choose to ignore the message and continue baking, or reset the reminder function. You will have approximately 15 hours of use in this mode before you receive this message again. • When the "Clean Convection Fan Filter" message appears on the screen, the variable function keys will be labeled OK, RESET UPR and/or RESET LWR. ◊ When you clean the filter(s) and want to reset the message and counter, touch the variable function key with the appropriate RESET label, then OK. RESET UPR will reset the upper or a single oven, RESET LWR will reset the lower oven on units equipped with two ovens. ◊ Touch OK alone to clear the screen and continue using oven without cleaning the filter. Doing so does not clear the warning. Next time the home screen is displayed, the message will reappear. Touching OK allows you to leave the message as a reminder if you are not ready to clean the filter, but still want to cook. Meat Probe Broil Pan • Your broil pan has a porcelain enamel finish. When you clean it, use a solution of detergent and hot water. If your broil pan is heavily soiled, use a scouring pad with plenty of water. Rinse it well after cleaning. Optional Roast/Broil Pan with V-Shaped Rack • Your roast/broil pan has a porcelain enamel finish. When you clean it, use a solution of detergent and hot water. If your roast/broil pan is heavily soiled, use a scouring pad and plenty of water. Rinse it well after cleaning. • The optional V-shaped rack is finished with an Excalibur® non-stick coating. When you clean it, use a solution of mild detergent and warm water. Use the side of a sponge to scrub it and dry it with a lint-free cloth. 31