Dacor ER30G Installation Instructions - Page 5

Important Safety Instructions, Installation Specifications

Page 5 highlights

Important Safety Instructions WARNING • For your safety, do not use the oven to cook without the convection filter installed. When the filter is not installed, the spinning fan blades at the back of the oven are exposed. • The cooktop should never be operated without the knobs and trim rings in place. • Non-stick coatings, when heated, can be harmful to birds. Remove birds to a separate, well-ventilated room during cooking. • Always ensure that the light fixture lens cover is in place when using the oven. The lens cover protects the light bulb from breakage caused by high oven temperatures or mechanical shock. IMPORTANT - This appliance is equipped with a three-prong grounding plug for your protection against possible electric shock hazards. Plug it only into a dedicated, grounded three-prong electrical outlet. It is the responsibility of the customer to make sure the proper type of outlet is installed. Do not under any circumstances: • Cut or remove the third (ground) prong from the power cord. • Use an adapter plug. • Use an extension cord. • Use a power cord that is frayed or damaged. • Connect to an electrical outlet with a ground fault interrupter (GFI). Installation Specifications Product Dimensions 45 9/16" (1157mm) 28 9/16" (725mm) 27 1/16" (687mm) 26 1/8" (664mm) 24" (610mm) 1 1/8" (29mm) All tolerances: ±1/16" (±1.6mm), unless otherwise stated Front of open door Front of handle Front edge of bullnose Front panel Rear of front panel Backguard thickness NOTE: Neither model is compatible with a raised vent. 1 9/16" (40mm) Product width: 29 7/8" (759mm) 9" (229mm) Grates extend Backguard*** 1" above trim 6" (152mm) 3" (76mm) Backguard* Backguard*** ER30GI: 2" (51mm) Partial stainless steel side panel 3" (76mm) ER30G: Full stainless steel side panels 35" (889mm) to 37 1/8" (943mm) 1 3/4" (44mm) Backguard** * Standard on model ER30G Optional on model ER30GI, NOT compatible with self-rimming installations ** Standard on model ER30GI Optional on model ER30G *** Optional on both models, NOT compatible with self-rimming installations ER30G is designed for freestanding installations. ER30GI is designed for installation in a recessed cabinet or island. ER30G is NOT equipped for self-rimming installation. Overall Dimensions 3

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20

3
Important Safety Instructions
Installation Specifications
Product Dimensions
For your safety, do not use the oven to cook without the convection filter installed. When the filter is not installed,
the spinning fan blades at the back of the oven are exposed.
The cooktop should never be operated without the knobs and trim rings in place.
Non-stick coatings, when heated, can be harmful to birds. Remove birds to a separate, well-ventilated room during
cooking.
Always ensure that the light fixture lens cover is in place when using the oven. The lens cover protects the light bulb
from breakage caused by high oven temperatures or mechanical shock.
IMPORTANT - This appliance is equipped with a three-prong grounding plug
for your protection against possible electric shock hazards. Plug it only into a
dedicated, grounded three-prong electrical outlet. It is the responsibility of the
customer to make sure the proper type of outlet is installed. Do not under any
circumstances:
Cut or remove the third (ground) prong from the power cord.
Use an adapter plug.
Use an extension cord.
Use a power cord that is frayed or damaged.
Connect to an electrical outlet with a ground fault interrupter (GFI).
WARNING
1 1/8” (29mm)
1 9/16”
(40mm)
2” (51mm)
3” (76mm)
Front of open door
Front of handle
Front edge of bullnose
Front panel
Rear of front panel
Backguard thickness
26 1/8” (664mm)
27 1/16” (687mm)
28 9/16” (725mm)
24” (610mm)
3” (76mm)
Backguard***
ER30G:
Full stainless
steel side panels
ER30GI:
Partial stainless
steel side panel
Grates extend
1” above trim
6” (152mm)
Backguard*
1 3/4” (44mm) Backguard**
***
**
*
Optional on both models,
NOT
compatible with self-rimming installations
Standard on model ER30G
Optional on model ER30GI,
NOT
compatible with self-rimming installations
Standard on model ER30GI
Optional on model ER30G
Product width:
29 7/8” (759mm)
ER30G is designed for freestanding install-
ations. ER30GI is designed for installation
in a recessed cabinet or island. ER30G is
NOT
equipped for self-rimming installation.
NOTE:
Neither model is
compatible with a raised vent.
35”
(889mm)
to
37 1/8”
(943mm)
9” (229mm)
Backguard***
45 9/16” (1157mm)
All tolerances: ±1/16” (±1.6mm), unless otherwise stated
Overall Dimensions