Dacor ER36G Use & Care Manuals - Page 8
Setting Up Your Range
View all Dacor ER36G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Setting Up Your Range Cooktop Assembly The burner rings spread the flame evenly around the burner cap. All burner parts must be properly seated for proper burner lighting and operation. To assemble the burners: 1. Remove the burner rings, burner caps and grates from their shipping packages. 2. Install the burners as shown below. Gently twist each piece back and forth after installation to make sure it is properly seated. A small gap below the burner ring is normal when installed properly. 3. Gently set each grate on top of the spill tray. Put the legs of each grate inside the corresponding dimples. Ridge on bottom Inner burner cap STEP 3: Set inner dual burner cap on center of dual burner base. Line up ridge on bottom of cap with pins on center of burner base. Outer burner cap STEP 2: Set outer dual burner cap on dual burner ring. Make sure it is centered on top. Burner ring STEP 1: Install dual burner ring on dual burner base. Line up indentations on bottom of burner ring with pins on top of burner base. Pin on burner base Dual Burner Assembly (left front and right front burners only) Ridge on bottom of burner cap STEP 2: Install all standard burner caps. Ridge on bottom of caps must surround top of ring. Igniter hole STEP 1: Install standard burner rings on standard burner bases. Put holes on edge of each ring over the igniter. Center tabs on bottom of each ring in hole in center of each base. Burner ring top view Igniter on burner base Standard Burner Assembly (left rear, right rear and both center burners) 6