Dacor ER48D Installation Instructions - Page 7

Planning the Installation Product Dimensions Product tolerances: ±1/16" (±1.6 mm) GAS - ELECTRICAL ACCESS DIMENSIONS Model A B C D E* ER36D 5 5/8" (142.9 mm) 18 3/8" (466.7 mm) 10 3/4" (273.0 mm) 13 11/16" (347.7 mm) 7/8" (22.2 mm) ER48D 3 13/16" (96.8 mm) 18 11/16" 9 3/8" 13 3/4" 1 1/8" (474.7 mm) (238.1 mm) (349.3 mm) (28.6 mm) * The diameter on models equipped for use in Canada is ¼" (6.4mm) larger Inlet than those stated. Canadian units come from the factory pre-wired with B an appliance cord. When installing an appliance cord on models that are not pre-wired, the hole size must be increased to 1 1/8" (1 3/8" for model ER48D) by removing the conduit bracket inside the range electrical access box. Gas regulator access, cover removed Range electrical access, cover removed Back of range D A C E Electrical connection hole in bottom 48" (1219 mm) 30 3/4" (781 mm) 29 3/8" (746 mm) 28 1/4" (718 mm) 26 1/8" (664 mm) (229 mm) Front of open door Front of handle Front edge of bull nose Front panel Rear of front panel/oven door (40 mm) (483 mm) (387 mm) (51 mm) 24" (610 mm) ** (229 mm) ** 1 1/16" (27 mm) to cooking surface (top of grates) from top of trim (76 mm) ** Finished side panel (940 mm) (908 mm) ** Optional Width: ER36D - 35 7/8" (911 mm) ER48D - 47 7/8" (1216 mm) 5