Dacor ETT365 User Manual - Millennia Cooktop - Page 4

2

Getting Started

Before operating the cooktop, clean the

glass ceramic surface carefully as outlined

in the Care and Cleaning Instructions. The

cooktop surface must be free of any foreign

substances, especially those that could melt

and permanently adhere to the glass.

During the first uses of your new cooktop, you

may smell a slight burning odor or see light

smoke. Both of these conditions are normal in

new glass ceramic cooktops.

Heating Elements

DACOR glass ceramic cooktops contain ribbon

type radiant heating elements in various sizes to

allow the user the greatest cooking flexibility.

The Ribbon Radiant Heaters illuminate within

approximately 3-4 seconds of activation. The

Dual Element consists of two elements which

may be operated simultaneously for heavy

cooking demands. The inner element may be

operated alone for improved simmering with

smaller utensils.

All elements feature temperature limiters to

ensure that the safe operating temperature of

the glass ceramic top is never exceeded.

DACOR glass ceramic cooktops operate by

automatically cycling the heating elements

between “off” and full power. As the numeric

setting of the control is increased, the element

will stay at full power for longer periods and at

zero power for shorter durations.

When the element is set to the dual range, both

the inner and outer elements will cycle on and

off at the same time. (The outer heating element

can never be operated alone.)

For maximum performance from any burner

remember to closely match heating element

diameters and cookware size.

Residual Heat Indicator Lights

All Dacor glass cooktops have element residual

heat indicator lights. These indicating lights

remain illuminated until the burner cools down to

a safe temperature of 140º degrees.

IMPORTANT:

Be certain that the cookware and glass

surfaces are clean and dry before you turn

on the burner and place a pot or pan on the

heating burner.

Element ON Indicator Light

One light indicating power is on to any of the

elements.

Setting the Controls

NOTE:

When at its highest setting, the heating

element may cycle off due to the protection

of the temperature limiter built into each

element. This temperature limiting occurs

automatically to prevent exceeding the

maximum allowable surface temperature and

to maintain the constant desired heat level.

The element will cycle back on after it has

cooled to a safe temperature.

ETT Models

To turn an element on, tap the “ON/OFF” key

then tap the up arrow for the desired element.

The element will come on at a setting of “5” and

may be adjusted up or down by pressing the

appropriate key.

To activate the Dual Element, tap the “ON/OFF”

key then tap the Dual Element Indicator to

activate the outer ring of the element. It will

come on at a setting of “5”, then tap the up

indicator for desired temperature setting.

To turn an element off, tap the “ON/OFF” key.

You may turn off all active elements at the same

time by tapping twice on the Dacor logo located

below the controls.

ETT Secure Lockout

To avoid accidentally turning the cooktop on

while cleaning it, activate the “Secure Lockout”

feature.

To lock out the cooktop:

Press and hold the DACOR logo for 3-4

seconds and the cooktop will be secured from

use. You will hear three beeps and a light will

illuminate directly above the DACOR logo

indicating that the cooktop is secure. The control

panel is now disabled and may be cleaned

without activating any functions.

To unlock the cooktop:

Press and hold the DACOR logo for 3-4

seconds. You will hear three beeps and the light

will go out. The control panel is now ready for

use.

NOTES:

1.

For maximum safety, the cooktop

will be in the “lock out” mode when

first installed, or whenever power

is interrupted. Follow the “Unlock”

instructions above to reactivate the

control panel.

2.

To turn off multiple burners all at one

time - tap the Dacor logo twice.

6 1/2"

1200W

7 3/4"

1800W

5 1/2"

1000W

7"

1500W

9 3/4"

2400W

Model ETT304

Top View

7"

1500w

7 3/4"

1800w

9"

2100w

6 1/2"

1200w

9 3/4"

2400w

5 1/2"

1000w

Model ETT365

Top View

CER Models

Push down and turn the knob to the desired

temperature setting. The control knobs can be

turned either clockwise or counterclockwise

to the desired temperature setting. The knob

that controls the Dual Element may be pushed

down and turned counter-clockwise to heat the

single inner element or clockwise to heat both

the inner and outer elements. All knobs may

be positioned below setting #1 to achieve the

lowest temperatures possible.

7"

1800W

5 1/2"

1000W

5 1/2"

1000W

7 1/2"

2000W

9"

2000W

Model CER304

Top View

ETT304/ETT365 Controls

Dacor ETT365 User Manual - Millennia Cooktop - Page 4

Getting Started, Heating Elements, Residual Heat Indicator Lights, Element ON Indicator Light,

Page 4 highlights