Dacor HGPR36 Use Care Manual - Page 22
Replacing the Oven Light
View all Dacor HGPR36 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Care and Cleaning Oven Racks CAUTION To prevent damage, do not leave the oven racks inside the oven during the self clean cycle. The oven racks are chrome-plated. To clean, apply a solution of detergent and hot water. To clean heavy soil, use the rough side of a sponge or a scouring pad with plenty of water, or use a solution of 1 cup ammonia to 2 gallons of water. Convection Filter (Oven) WARNING • The convection filter is made of stainless steel. Remove it only when it is cool. • Re-install the filter before cooking in the oven again. Failure to do so will expose the convection fan blade that rotates at high speed during convection modes. Convection Filter Removal and Cleaning • Remove the filter regularly for cleaning. A clogged filter will reduce the effectiveness of convection cooking. Soak it in hot soapy water. Dry it completely before re-installing. • To reinstall, orient the filter so that the mounting clips are towards the rear of the oven, open end down. Hook the mounting clips over the top of the horizontal edge across the opening. Clips on back of filter Horizontal edge Replacing the Oven Light WARNING • To prevent an electrical shock hazard and/or personal injury, make sure that power to the range has been disconnected and that the light fixture is cool before replacing the light bulb. • Always ensure that the lens cover is in place when using the oven. The lens cover protects the bulb from breakage caused by high oven temperatures or mechanical shock. • Replacing the lens cover without lining up the cutout with the light socket will damage the light fixture. • Do not use a screwdriver to remove the lens. Replacing a Light Bulb Light bulb replacement is considered a homeowner maintenance operation. If the light does not work, before replacing it, please consult the Problem Solution Guide on page 21. 1. Replace the light bulb only with Dacor part number 108774. See page 23 for ordering information. IMPORTANT: Do not touch the replacement halogen light bulb with your fingers. Halogen bulbs are sensitive to the oils from your hand. The oils from your hand will stick to the bulb and may cause it to burn out faster than normal. 2. Disconnect the power cord from the electrical outlet. 3. Remove the rack support in front of the light. 4. Hold your hand under the lens for support and gently pry it loose using a spatula or table knife. Pull the lens cover straight out. Light fixture Bulb 5. Grasp the old bulb and pull it straight out of the socket. 6. Using a glove, insert the new bulb into the socket. 7. As you reinstall Light socket the lens cover, line up the Lens cutout Lens cutout on the inside rim with the light socket. Gently press it into its original position. 8. Replace the rack support and reconnect the power cord. 20