Dacor HGPR48 Installation Instruction - 48" 36" Pro Gas Range - Page 6
Cabinet Layout
View all Dacor HGPR48 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Planning the Installation Cabinet Layout • All maximum/minimum dimensions and clearances in the diagrams below must be maintained for safe operation. • Install the range away from drafts, and include a hood or approved downdraft. • For safety's sake, do not install cabinets above the range; otherwise, install a hood that extends 5" or more past the cabinet face. • The range may be installed against the rear wall. You should install a backguard or non-combustible material on the wall between the range and hood. Non-combustible material is not needed behind the range from countertop to floor. • Seal openings in the wall behind the range or in the floor below. Gas and Electrical Service • The shaded area in the diagram below shows the recommended location of the gas inlet and the electrical outlet. (If replacing a range, the existing utilities may be used if they do not interfere with the placement of this range. Check local codes for permissible gas-valve locations.) • An external, manual shut-off valve must be installed between the gas inlet and range so the gas supply can be turned on/off • The installation must also allow: -- access to the gas shut-off valve when the unit is installed. -- access to the electrical outlet, when the range is in place. -- the range to be pulled out for service without disconnecting the gas and electrical supply. Model F HGPR36S 42" (106.2 cm)*; 36" (91.4 cm)** HGPR48S 54" (137.2 cm)*; 48" (121.9 cm)** * Recommended ** Minimum DIMENSIONS G H 36" (91.4 cm)** 33 1/2" (84.8 cm) 48" (121.9 cm)** 43 1/2" (110.2 cm) I 30 7/8" (78.4 cm) 29 7/8" (75.9 cm) J 3 1/2" (8.9 cm) 3" (7.6 cm) Cutout tolerances: +1/16" (+1.6 mm), -0 unless otherwise stated F Backsplash J 3/8" (1.0 cm) min. for downdraft cap non-combustible clearance rear wall (recommended) H 13" (33.0 cm) max.5 Non-combustible surface along back wall recommended Note 2 10" (25.4 cm) min. to combustible side walls above the range (on both sides) 15" (38.1 cm) min.4, 5 Note 2 37 1/2" (95.3 cm) max. 4 30" (76.2 cm) min.1 G Grate level Suggested location of utilities 3 10" (25.4 cm) min. to combustible side walls above the range (both sides) 1 Vertical from range grate level to combustible overhead surface; if installing an overhead vent hood, also check hood specifications for minimum required clearances. 2 Cabinet/countertop depth is at discretion of customer but cabinet face MUST NOT protrude further than rear of front panel, see product dimensions. 3 Consult local code for exact location requirements. 4 Vertical from grate level to combustible surface. 5 This specification does not apply for cabinets more than a horizontal distance of 10" (25.4 cm) from the edge of the range. G Range HGPR36S HGPR48S Range HGPR36S HGPR48S Downdraft Vent ERV36-ER ERV48-ER 1.5" Low-Profile Backguard APB36GLP APB48GLP