Dacor IVSR1 Use & Care Manuals - Page 4

Operating Controls Care and Cleaning Your Dacor IVS has two knobs that control the halogen lights and the exhaust blower. Turning the knobs clockwise will turn on the lights and the blower. When turning the lights or blower off, turn the knob counter-clockwise until it clicks. Blower Knob: The further clockwise you turn the knob the faster the blower runs. Light Knob: The further clockwise you turn the knob the brighter the light. Turn the knob until you reach the desired light level. Proper cleaning is necessary to maintain performance and appearance, while also ensuring safe operation. The frequency of cleaning should be adjusted according to the type and amount of cooking. Best results will be achieved by cleaning soiled components as soon as possible. The filters must be cleaned regularly. Remove one filter at a time, grasp the filter handle and gently push back and pull the front down. The filters may be cleaned by hand washing in hot water with a mild detergent solution or by placing them in an automatic dishwasher. Dry the filters completely before using them again. Fan Knob Light Knob OPERATING TIPS: 1. Activate the blower a few minutes before starting to cook to establish an airflow pattern in the room. 2. Adjust the fan speed according to the volume and weight of the cooking exhaust. 3. Always activate the blower whenever using the cooking appliance. 4. Eliminate air currents in the hood's vicinity by shutting nearby windows and doors, turning off ceiling fans and closing adjacent heating and air conditioning outlets. 5. Place your largest pans, skillets and stock [pots on the rear burners whenever possible. STAINLESS STEEL, BRASS & CHROME SURFACES should be cleaned with a solution of mild detergent and warm water. Rinse and dry with a soft lint-free cloth. CAUTION: If commercially available stainless steel cleaners are used, it is important to read the labels for chlorine compounds. Chlorine is a corrosive substance. If these compounds are present, rinse thoroughly and dry with a soft lint-free cloth. Follow manufacturer's instructions for application of polish. Always wipe stainless steel surfaces with the grain. Never wipe across the grain. After cleaning, reinstall the filters carefully. WARNING: Do not operate the IVS without the filters in place or with dirty, grease-laden filters. Changing the Light Bulb The suction cup, part number 62408, supplied with the IVS, is designed to assist in the removal and replacement of the halogen light bulbs, should they burn out. To remove a bulb, simply press the suction cup onto the face of the bulb and unscrew in a counter-clockwise direction (as you are facing the bulb). To install the new bulb, start the new bulb in the socket in a clockwise direction by turning a few times by hand, then attach the suction cup to the face of the bulb and complete the installation. Keep the suction cup in a safe place for future maintenance. For replacement lamps, contact your Dacor parts distributor and order part number 62351. Energy Saving Tips 1. Do not operate the blower at a speed that is higher than necessary to remove the cooking exhaust. Running at excessive speeds removes more air from the inside of the house that must be replaced by outside air. This may be especially costly when the housing air conditioning or heating system is in operation. 2. Clean filters and grease-laden surfaces often to improve efficiency. 3. Turn off the blower as soon as all cooking smoke and odors have been eliminated. 4. Always use lids on cookware to retain heat and moisture. 5. Minimize the amount of liquid used to cook food. 6. Select cookware of the proper size, material and construction for the cooking task being performed. 2