Dacor PCS130 Installation Instruction - Classic Wall Oven - Page 11

Installation Instructions Installing the Exhaust Grill With the oven now secured to the cabinet, install the Exhaust Grill by mounting it to the oven with the two screws provided. NOTE: You may need to loosen the side mounting screws a little to align the Exhaust Grill mounting holes. Tighten the side mounting screws after attaching the Exhaust Grill. Exhaust Grill #8 Screw Reinstalling the Oven Doors WARNING WARNING - Failure to fully rotate the hinge catches will cause them to bend when the door is closed. This will make closing the door impossible. Grasp the oven door on opposite sides and lift it until the door hinges are aligned with the openings in the oven frame. Holding the door at about a 30˚ angle from the horizontal, slide the hinges into the openings until the bottom hinge arms drop fully into the hinge receptacles. Lower the door to the fully opened position, and then rotate the two hinge catches toward the oven. Open and close the door completely to ensure that it is properly installed. For double ovens, complete Verifying Oven Operation for both the upper and lower doors. Attaching the Exhaust Grill For stainless steel ovens, peel off the protective layer of plastic that covers the door panel. Verifying Oven Operation Verifying Oven Operation Slide the oven racks onto the support racks within the cavity. Place the broiler pan and tray on a rack within the oven, if desired. Turn on the power supply to the oven. Set the time of day by pressing the Clock touch pad then pressing the TIME•TEMP key. Press the BAKE selector pad for the upper oven or single oven. Select a temperature of 350˚F by pressing the TIME•TEMP "+" key. The oven should now be heating. After approximately three (3) minutes, the lower heating element should glow red. Press the CANCEL•SECURE pad to stop the oven heating process. It may take longer than three (3) minutes when ovens are running at voltages lower than 240V. If checking the operation of the double oven, repeat the bake test for the lower oven. Press the BROIL selector pad for the upper oven or single oven. Select a temperature of 350˚F by pressing the TIME•TEMP "+" key. The oven should now be heating. After approximately three (3) minutes, the upper heating element should glow red. Press the CANCEL•SECURE pad to stop the oven heating process. It may take longer than three (3) minutes when ovens are running at voltages lower than 240V. If checking the operation of the double oven, repeat the broil test for the lower oven. Secure oven to cabinet with screws provided Single Ovens - 4 screws Double Ovens - 6 screws Installing the Cabinet Mounting Screws WARNING WARNING - If the oven does not operate properly, follow these troubleshooting steps: 1. Verify that power is being supplied to the oven. 2. Check the electrical connections to ensure that the installation has been completed correctly. 3. Repeat the above bake test. 4. If the appliance still does not work, contact an authorized Dacor service company. If you are unable to locate a Dacor Servicer, please contact Dacor at (800) 793-0093, or visit us on the web at www.Dacor. com. Do not attempt to repair the appliance yourself. Dacor is not responsible for service required to correct a faulty installation. 9