Dacor PGM304 Installation Instruciton - Preference Cooktop - Page 9
Installing the Burner Components
View all Dacor PGM304 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Installation Instructions Installing the Burner Components warning • Never attempt to operate the cooktop with any of the burner parts removed. • Do not attempt to adjust the burner air mixture settings. All adjustments are preset at the factory. 1. Remove the burner heads, burner rings, burner caps and grates from their shipping packages. 2. Install the burners as shown. When installing the burner components, twist each piece back and forth until it drops completely into place. The burners will not operate properly unless all of the burner pieces are properly seated. 3. Gently set the grates on top of the spill tray. Make sure that the rubber feet are positioned in the locating dimples. Cap Cover Burner Cap Grate Put Hole in Bottom of Burner Head Over Pin on Top of Cross Ring Insert Pin on Bottom of Cross Ring into Hole on Base Burner Head Wide Side Down! Skirt Cross Ring Base Line Up Notch on Bottom of Head with Igniter Cap Cover Burner Head Dual Burner Assembly PGM Burner Components Single Burner Assembly 7