Dacor PHG30 Planning Guides - Page 1

Dacor PHG30 Manual

Page 1 highlights

Document # PG07-003 PHW 30 Inch and 36 Inch Wide Glass Wall Mount Range Hoods Revised 01/25/11 Page 1/1 PLANNING GUIDE Product tolerances: ±1/16" (±1.6 mm), -0, unless otherwise stated 10 3/4" (27.3 cm) 11 7/8" (30.2 cm) 26 1/8" (66.4 cm) min.* 44" (111.8 cm) max.* 25 3/8" * 19 3/4" * (64.5 cm) (50.2 cm) 8" dia. 203.2 cm) warning • Observe all governing codes and ordinances during planning and installation. Contact your local building department for further information. • This appliance must be installed in accordance with the accompanying installation instructions. • The minimum installed distance from the rear of blower unit base to the cooktop surface must be no less than 30" inches (76.2 cm), 26 inches (66.0 cm) for an electric cooktop. The minimum specified distance may be higher for the particular range or cooktop in use. Check the manufacturers specifications for the cooktop or range. • DO NOT install an additional in-line or external blower to increase the length of the duct run. Even small differences between blower air flow rates can greatly reduce the air draw of the hood. 5 3/4" (14.6 cm) 19 3/4" (50.2 cm) 30" (76.2 cm) or 36" (91.4 cm)** * Glass thickness of 5/16" (3 mm) not included ** Glass width must be specified at time of order. Specify glass part number: PHGXXBK where XX is the width. overall dimensions 8" (20 cm) Chimney Mounting Bracket 5/16" (3 mm) General Specifications Blower 600 CFM with electronic speed control Blower Speeds Lights Filters Exhaust Finish Power Required Circuit Required 4 120 Vac, 50 Watt halogen (1) Mesh type, dishwasher safe (2) 8 inch 430 stainless steel with tempered glass hood 120 Vac, 60 Hz., 3.5 Amp. 120 Vac, 60 Hz., 15 Amp. 3-wire (hot, neutral, ground), grounded, dedicated circuit Min. Maximum Duct Length The maximum straight duct length for the hood is 50 feet. To determine the actual maximum duct run, subtract the equivalent length of each elbow, transition and cap from 50 feet. See the Duct Planning Guide or the installation instructions for more details. 30" min. (76.2 cm) Specifications subject to change without notice. www.Dacor.com The hood may exhaust through the ceiling on through a rear wall. Rear of blower unit Glass Cooktop surface EXAMPLE OF REAR EXHAUST Installation - Side View Phone: (800) 7937-0.3093

  • 1

PLANNING
GUIDE
Specifications subject to change without notice.
Phone: (800) 793-0093
www.Dacor.com
5/16”
(3 mm)
30” min.
(76.2 cm)
Rear of blower
unit
Cooktop
surface
Glass
30 Inch and 36 Inch Wide
Glass Wall Mount Range Hoods
PHW
5 3/4”
(14.6 cm)
8” dia.
203.2 cm)
10 3/4” (27.3 cm)
11 7/8” (30.2 cm)
26 1/8” (66.4 cm)
min.*
44” (111.8 cm)
max.*
25 3/8” *
(64.5 cm)
19 3/4”
(50.2 cm)
19 3/4” *
(50.2 cm)
30” (76.2 cm) or
36” (91.4 cm)**
* Glass thickness of 5/16” (3 mm) not included
** Glass width must be specified at time of order. Specify glass
part number: PHGXXBK where XX is the width.
OVERALL DIMENSIONS
Blower
600 CFM with electronic speed control
Blower Speeds
4
Lights
120 Vac, 50 Watt halogen (1)
Filters
Mesh type, dishwasher safe (2)
Exhaust
8 inch
Finish
430 stainless steel with tempered glass hood
Power Required
120 Vac, 60 Hz., 3.5 Amp.
Circuit Required
120 Vac, 60 Hz., 15 Amp. 3-wire (hot, neutral,
ground), grounded, dedicated circuit Min.
GENERAL SPECIFICATIONS
Product tolerances: ±1/16” (±1.6 mm), -0, unless otherwise stated
8” (20 cm)
CHIMNEY MOUNTING
BRACKET
INSTALLATION - SIDE VIEW
WARNING
Observe all governing codes and ordinances during planning
and installation. Contact your local building department for
further information.
This appliance must be installed in accordance with the
accompanying installation instructions.
The minimum installed distance from the rear of blower unit
base to the cooktop surface must be no less than
30” inches (76.2 cm), 26 inches (66.0 cm) for an electric
cooktop. The minimum specified distance may be higher
for the particular range or cooktop in use. Check the
manufacturers specifications for the cooktop or range.
DO NOT install an additional in-line or external blower to
increase the length of the duct run. Even small differences
between blower air flow rates can greatly reduce the air draw
of the hood.
Document # PG07-003
Revised 01/25/11
Page 1/1
The hood may exhaust through
the ceiling on through a rear wall.
EXAMPLE OF REAR
EXHAUST
Maximum Duct Length
The maximum straight duct length for the hood is 50 feet. To determine
the actual maximum duct run, subtract the equivalent length of each
elbow, transition and cap from 50 feet. See the Duct Planning Guide or the
installation instructions for more details.